IRNew_Part3.pdf

During circling-to-land (with or without prescribed flight track), the maximum allowed airspeed for a Cat B aeroplane, in order to remain within the protection envelope is: A – 125 kt B – 120 kt C – 135 kt D – 150 kt Ref: AIR: atpl, ir; HELI:...

During circling-to-land (with or without prescribed flight track), the maximum allowed airspeed for a Cat B aeroplane, in order to remain within the protection envelope is: A – 125 kt B – 120 kt C – 135 kt D – 150 kt Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 5. The MSA, which must be established around a navigation facility, is in general valid within a sector of: A – 30 NM B – 10 NM C – 15 NM D – 25 NM Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 6. How many separate segments has an instrument approach procedure? A–3 B – Up to 5 C–4 D – Up to 4 Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 7. The ILS glide path is normally intercepted between: A – 5 and 10 NM B – 3 and 7 NM C – 4 and 8 NM D – 3 and 10 NM Ref: AIR: atpl, ir; HELI: atpl, ir  Ans: D 8. The optimum descent gradient in the final approach should not exceed: A – 6.5 percent B – 3 percent C – 5 percent D – 7.5 percent Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 9. If you lose the necessary visual references while “circling visual”, you should: A – turn towards the airport maintaining the visual circling altitude/height B – start the missed approach procedure C – make an initial climbing turn towards the landing runway and when overhead the airport climb on the missed approach track D – climb straight ahead to MSA Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 10. In a precision approach (ILS), generally glide path intersection occurs at heights above runway elevation from: A – 150m (492 ft) to 300m (984 ft) B – 300m (984 ft) to 600m (1968 ft) C – 300m (984 ft) to 900m (2955 ft) D – 150m (492 ft) to 900m (2955 ft) Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 11. For a circling approach, the minimum OCH above aerodrome level is: A – 200 ft B – depends on aircraft category C – 394 ft D – 591 ft  Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 12. On a non-precision approach a so-called “straight-in-approach is considered acceptable, if the angle between the final approach track and the runway centre line is: A – 40 degrees or less B – 30 degrees or less C – 20 degrees or less D – 10 degrees or less Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 13. During an instrument approach, followed by a missed approach, the minimum obstacle clearance (MOC) in the intermediate phase of this missed approach is: A – 90m (295 ft) B – 50 m (164 ft) C – 30 m (98 ft) D – 120m (384 ft) Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 14. A turn executed by the aircraft during the initial approach between the end of the outbound track and the beginning of the intermediate or final approach track is a: A – Procedure turn B – Base turn C – Reversal procedure D – Race track Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 15. Minimum sector altitudes are determine by the inbound radial in relation to the IAF. These sectors are established for a distance from the IAF of: A – 5 NM B – 20 NM C – 10 NM D – 25 NM Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 16. During an instrument approach, the minimum obstacle clearance (MOC) of the initial approach segment primary area is equal to: A – 150m (492 ft) B – 210m (690 ft) C – 300m (984 ft) D – 120m (394 ft) Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 17. The width of the corridor around a specified arrival route is: A – ±12.5 NM B – ±10 NM C – ±5 NM D – ±2.5 NM Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 18. You are on an IFR flight executing a circling approach. A descend below the MDA should not be made until: 1. the pilot has the landing threshold in sight 2. visual reference has been established and can be maintained 3. the required obstacle clearance can be maintained and a landing can be made The combination regrouping all the correct answers is: A – 2, 3 B – 1, 2 C – 1, 2, 3 D – 1, 3 Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 19. The protection areas associated with instrument approach procedures are determined with the assumption that turns are performed at a bank angle of: A – 25o or the bank angle giving a 3o/s turn rate, whichever is lower, for departure and approach instrument procedures, 25o for circling-to-land with prescribed flight tracks and 15o for missed approach procedures B – 25o or the bank angle giving a 3o/s turn rate, whichever is lower, for departure and approach instrument procedures, as well as circle-to-land, and 15o for missed approach procedures C – The bank angle giving a 3o/s turn rate for all procedures with airspeed limitation related to aeroplane categories D – 25o or the bank angle giving a 3o/s turn rate, whichever is lower, for departure, approach or missed approach instrument procedures, as well as circling-to-land (with or without prescribed flight tracks) Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 20. Which are the phases of a missed approach procedure? A – Arrival, intermediate and final B – Arrival, initial, intermediate and final C – Initial, intermediate and final D – Initial and final Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C 21. Which is the minimum obstacle clearance within the primary area of an intermediate approach segment? A – 150 m B – 150 ft C – 300 m D – 300 ft Ref: AIR: atpl, ir; HELI: atpl, ir Ans: A 22. If visual reference is lost while circling to land from an instrument approach, it  is expected that the pilot will make an initial climbing turn towards the: A – Landing runway B – MAP C – FAF D – Final missed approach track Ref: AIR: atpl, ir; HELI: atpl, ir Ans: A 23. Who is establishing the aerodrome operational minima for instrument approaches? A – The appropriate authority of the State of the aerodrome B – The State of Registry of the aircraft C – The operator D – The appropriate authority of the State of the aircraft operator Ref: AIR: atpl, ir; HELI: atpl, ir Ans: A 24. An instrument approach procedure consists of: A – 5 segments B – 4 segments C – 6 segments D – 3 segments Ref: AIR: atpl, ir; HELI: atpl, ir Ans: A 25. During an instrument approach, followed by a missed approach, the minimum obstacle clearance (MOC) in the final phase of this missed approach is: A – 120m (384 ft) B – 30m (98 ft) C – 90m (295 ft) D – 50m (164 ft) Ref: AIR: atpl, ir; HELI: atpl, ir  Ans: D 26. What is the normal procedure design climb gradient for a missed approach procedure? A – 3o B – 2.5% C – 3.3% D – 2.5o Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 27. In the primary area, the obstacle clearance for the initial approach segment provides at least: A – decreasing from 984 to 492 ft B – 1476 ft C – 492 ft D – 984 ft Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 28. The primary area of an instrument approach segment is: A – the most critical part of the segment where the minimum altitude should be kept very carefully B – a defined area symmetrically disposed about the normal flight track in which full obstacle clearance is provided C – the first part of the segment D – the outside part of the segment where the obstacle clearance increases from 0 ft to the appropriate minimum Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 29. Under what circumstances would an ILS glide path in excess of 3o be used? A – Where other means of obstacle clearance are impracticable B – For aircraft with STOL capabilities  C – Where noise abatement restrictions make a less steep approach impracticable D – Parallel runway operations Ref: AIR: atpl, ir; HELI: atpl, ir Ans: A 30. Where does the initial section of a missed approach procedure end? A – When a height of 50 m has been achieved and maintained B – When established in the climb C – At the missed approach point D – When en-route either to hold or departure Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 31. Where does the initial approach segment in an instrument approach procedure commence? A – At the IF B – At the IAF C – At the FAF D – At the final en-route fix Ref: AIR: atpl, ir; HELI: atpl, ir Ans: B 32. Were an operational advantage can be obtained, an ILS procedure may include a dead reckoning segment from a fix to the localiser. The DR track will: A – Intersect the localiser at 30o and will not be more than 10 NM in length B – Intersect the localiser at 30o and will not be more than 5 NM in length C – Intersect the localiser at 45o and will not be more than 5 NM in length D – Intersect the localiser at 45o and will not be more than 10 NM in length Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 33. In the ILS-approach, the OCA is referenced to: A – Aerodrome elevation B – Aerodrome reference point C – Relevant runway threshold D – Mean sea level Ref: AIR: atpl, ir; HELI: atpl, ir Ans: D 34. In a precision approach (ILS), the final approach segment begins at the: A – FAF B – MAP C – FAP D – IF Ref: AIR: atpl, ir; HELI: atpl, ir Ans: C