Road Conditions Terminology Policy (Northern Territory) 2014 PDF

ROAD CONDITIONS TERMINOLOGY POLICY ROAD CONDITIONS TERMINOLOGY November 2014 Version 1.0 DEPARTMENT OF TRANSPORT  ROA...

ROAD CONDITIONS TERMINOLOGY POLICY ROAD CONDITIONS TERMINOLOGY November 2014 Version 1.0 DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY Owner: Department of Transport Manager: Transport Infrastructure Planning Division ___________________________________________________________________ INTRODUCTION It is desirable to have standard terminology for the reporting of road conditions that can be used consistently across all areas of communications, in formal road reporting and for all road users. This Directive details terminology to be used, particularly in formal road reporting. TYPES OF RESTRICTIONS 1. Detour An alternative route available for traffic during a temporary closure of a road, or part of that road. Detours may be sealed or unsealed. 2. High Clearance A light vehicle with clearance sufficient to travel over rough and uneven road surfaces. The clearance on these vehicles generally exceeds common passenger vehicles. 3. High Clearance 4WD A light vehicle with two axles that is built for on and off road use and clearance sufficient to travel over rough and uneven road surfaces. The clearance on these vehicles generally exceeds common passenger vehicles. 4. Impassable Access along the section of road is affected by flooding or other obstructions. Road conditions are likely to change rapidly and may present an extreme hazard. Persons should not attempt to use/access the road. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 5. Lane Closure Temporary closure of one or more traffic lanes. Traffic control devices are in place -to enable traffic to use unaffected lanes. 6. Road Closed Temporary closure of the road where passage of motor vehicles is not permitted. Barriers are in place and penalties shall be applied to drivers ignoring the road closure. Vehicle insurance may be void should drivers attempt to use the closed road. 7. Weight and Vehicle Type Restriction A restriction placed on heavy vehicles to control axle group loads and/or vehicle size to protect the road during adverse conditions. 8. With Caution The condition of part of the road may have deteriorated so that due care must be exercised by the travelling public. 9. 4WD A light vehicle with two axles that is built for on and off road use. All four wheels can be engaged to improve traction in adverse conditions. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY DETAILS OF RESTRICTIONS 1. Empty Empty Travel Permitted – An unladen load-carrying vehicle is not limited to the maximum number of axle restriction, where such a restriction exists. However, a load-carrying vehicle with a mix of loaded and empty trailers is subject to the maximum number of axle restriction, where such a restriction exists. Spare tyres and load restraint devices such as folded tarpaulins and side gates are allowed to be carried on empty trailers. A doubled-up trailer is considered loaded. 2. Gross Vehicle Mass (GVM tonnes) The maximum loaded mass of a vehicle, as specified by the manufacturer. It includes the tare and loaded mass of the vehicle, but not including loaded trailers. The GVM of a heavy vehicle is recorded with the Registrar, and is shown on the registration sticker. 3. Heavy Vehicle A motor vehicle with a GVM exceeding 4.5 tonnes. Typically these include buses, rigid trucks, semi-trailers and multiple trailer road trains. 4. Legal Limits Loads carried by the axles or axle groups of heavy vehicles that conform to the requirements of the Motor Vehicles Act and associated Regulations. 5. Light Vehicle A motor vehicle with a GVM less than 4.5 tonne. Typically these include passenger cars and 4WD vehicles, small motorhomes and minibuses, and other small passenger vehicles. Towing trailers and caravans is permitted under a light vehicle description, provided the GVM limit is compliant. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 6. Maximum Axles The maximum number of axles of a motor vehicle and its trailers when in operation. Thresholds that apply will be 4, 7 or 13 axles. 7. Night Closure Temporary closure of the road for the safety of the public generally between the hours of 6pm and 6am. Barriers are in place and penalties shall be applied to drivers ignoring the road closure. 8. No Overmass Permit Vehicles Vehicles operating under an Oversize/Overmass permit are not permitted to travel until the restriction is revoked. 9. Percentage - Axle Group Limit (AGL) Restrictions imposed on the mass of an axle or axle group for heavy vehicles. The percentage reduction to 60% or 80% applies to the Legal Limits prescribed in the Motor Vehicles Act and associated Regulations. Percentage reduction does not apply to steer axle. 10. Roadwork A general term for all work that is carried out within the road reserve area for construction, repair or maintenance. This includes work on or beside the road and any vehicle incident or recovery action. 11. Steep Grade A steep incline or decline that may restrict use by certain vehicle types. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 12. Tight Bends A series of one or more bends and curves in the road alignment that may restrict use by certain vehicle types. 13. Water Over Road Water is present over all or part of the road but the road is still trafficable, with caution. Refer also “Stream Crossings”. 14. Changed Traffic Conditions A temporary or permanent change to traffic conditions. For example, a new posted speed limit, roundabout or duplication of the road carriageway. SURFACE CONDITION 1. Boggy Conditions An unsealed road surface that is wet and soft, which may lead to a vehicle becoming bogged. Can also apply to loose dry conditions. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 2. Bulldust A very fine material with flour like texture often covering surface irregularities or deep holes. 3. Changing Surface Conditions The condition of the road surface may change along the length of the road, and following road maintenance activities. Wet weather may also cause a localised change in road condition. 4. Corrugations An unsealed road surface having ripples or undulations along the road. 5. Floodway A localised section of road designed to accommodate temporary overtopping allowing water to flow over the surface of the road. Refer also “Stream Crossing”. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 6. Loose Surface A layer of unbound or coarse material on the pavement surface. Can be very fine material (bull dust or sand), or large material in coarse gravel pavements. 7. Pot Holes Bowl-shaped depressions in the road surface, resulting from the loss of pavement material. 8. Rough The consequence of irregularities, uneven in nature, in the longitudinal profile of a road with respect to the intended profile. Interpretation of conditions will not allow vehicles to use the road at customary speeds. 9. Rutting A longitudinal deformation of a pavement surface formed by the wheels of vehicles. May be on a sealed or unsealed road. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY 10. Slippery Surface Surface becomes slippery in wet conditions or from fuel or material spills. 11. Stream Crossing Natural watercourses that cross the road alignment. On sealed roads the crossing would generally be a bridge, floodway or culvert. On unsealed roads there may be no structure. Water levels at floodways and stream crossings are likely to change rapidly and may present an extreme hazard. The ability to cross these floodways and streams will depend on depth of water, velocity of flow, driver experience and vehicle type. ALWAYS assess conditions prior to crossing or travelling along the affected section. See also “Water over Road”. 12. Washouts Steep, irregularly sided grooves in the road surface caused by erosion of the road surface by water. DEPARTMENT OF TRANSPORT  ROAD CONDITIONS TERMINOLOGY ROAD TYPES 1. Formed An unsealed road that has been constructed to above the natural surface using local materials. Generally of a higher standard than unformed. 2. Gravelled An unsealed road that has been formed and strengthened with a good quality gravel material. Generally of a higher standard than formed. 3. Sealed A road that is constructed with a bitumen surface. 4. Unformed An unsealed road that is generally a flat track following the natural terrain. Often occurs as a rough track with two wheel paths, and close vegetation. 5. Unsealed A road without a bituminous surface that could be gravelled, formed or unformed. DEPARTMENT OF TRANSPORT