Lighting and Target Types in Sports Championships Quiz
18 Questions
0 Views

Choose a study mode

Play Quiz
Study Flashcards
Spaced Repetition
Chat to lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

What is the allowable height range for Target Centers when measured from the level of the firing point floor?

  • Standard Height-1.8 M, Variation Allowable +0.15m /- 0.15m
  • Standard Height-2.0 M, Variation Allowable +0.25m /- 0.25m
  • Standard Height-1.4 M, Variation Allowable +0.10m /- 0.20m
  • Standard Height-1.0 M, Variation Allowable +0.20m /- 0.10m (correct)

    • In ISSF Championships, what types of targets are used?

  • Only electronic scoring targets (EST)
  • Only paper targets
  • Both electronic scoring targets (EST) and paper targets (correct)
  • None of the above

    • What is the minimum general lighting requirement for Finals Ranges?

  • 200 Lux (correct)
  • 1000 Lux
  • 1500 Lux
  • 500 Lux

    • How are Target Centre Locations measured?

    <p>To the center of the ten (10) ring</p> Signup and view all the answers

    What is the requirement for the height of Target Centers within a group of targets or range?

    <p>They must be within ±1cm of each other.</p> Signup and view all the answers

    What is the maximum allowable horizontal variation for Firing Points?

    <p>1.0 M</p> Signup and view all the answers

    Where is the recommended location for the 45-degree reference lines?

    <p>On range walls or section dividers to the left or right of the firing points</p> Signup and view all the answers

    Where should the firing point dimensions be for 25m Rapid Fire Pistol events?

    <p>Width 1.5m &amp; Depth 1.5m</p> Signup and view all the answers

    What purpose do the small transparent screens between firing points serve?

    <p>Protect athletes from ejected cartridge cases and allow visibility</p> Signup and view all the answers

    How are 25m ranges typically divided in terms of target groups?

    <p>Four groups of three targets each</p> Signup and view all the answers

    What is required between the area for athletes and officials and the space allocated for range officials, the Jury, and spectators?

    <p>A clear line of sight</p> Signup and view all the answers

    What is the recommended minimum target lighting in Lux for indoor ranges?

    <p>300 Lux</p> Signup and view all the answers

    In the mentioned events, what is the range of acceptable ring thickness?

    <p>0.7mm to 1.2mm</p> Signup and view all the answers

    What are the minimum visible width and height sizes of the target card in the mentioned events?

    <p>Width: 530mm; Height: 520mm - 550mm</p> Signup and view all the answers

    What is the measurement of the Inner Ten in the 25m Rapid Fire Pistol event and the Rapid Fire stages?

    <p>50mm (±0.2mm)</p> Signup and view all the answers

    What is the width of the Black from the 5 to 10 rings in the mentioned events?

    <p>500mm (±2.0mm)</p> Signup and view all the answers

    How should the zone numbers in the scoring zones be in terms of height and thickness?

    <p>Approximately 15mm high, 1.5mm thick</p> Signup and view all the answers

    Which scoring ring values are printed in the scoring zones in the mentioned events?

    <p>6 – 10</p> Signup and view all the answers

    More Like This

    Use Quizgecko on...
    Browser
    Open
    Browser
    Browser