Competition Document Submission Guidelines

Play an AI-generated podcast conversation about this lesson

What is the purpose of submitting documents via the competition website?

To obtain feedback from authorized judges and officials

To agree to the officials reproducing and distributing the documents for educational purposes (correct)

To allow the team to reproduce and distribute the documents

To enable judges to view and evaluate the documents

What happens if a team submits documents that are largely incomplete or not readable?

They will be considered as not submitted (correct)

They will be sent back to the team for completion

They will be considered as submitted with low score

They will be reviewed by the judges partially

What is the consequence of submitting forged documentation by a team?

The team will be de-registered from the competition (correct)

The team will be penalized with a score deduction

The team will be disqualified from the competition

The team will receive a warning

Who can view uploaded documents on the competition website?

Authorized judges, officials, and the submitting team Signup and view all the answers

What is the purpose of the prescribed method for submitting documents?

To ensure documents are submitted in the correct format Signup and view all the answers

What type of documents need to be submitted according to the competition rules?

Both template-driven and non-template driven documents Signup and view all the answers

What is the Young's Modulus (E) used for continuous material calculations?

200 GPa Signup and view all the answers

What is the minimum wall thickness for a tubing to be considered structural?

1.2 mm Signup and view all the answers

What is the maximum angle allowed for a support tube from the plane of the supported tube?

30° Signup and view all the answers

What percentage reduction is applied to nominal and tested adhesive values for bonded joints?

50% Signup and view all the answers

What is the requirement for the attachment point of a support tube on a bent tube?

At the position where it deviates farthest from a straight line Signup and view all the answers

What is the requirement for documenting bonded joints in the primary structure?

Documentation is required for all bonded joints Signup and view all the answers

What is the minimum distance required between tubes in the side view of the frame?

100 mm Signup and view all the answers

Where must the front hoop bracing structure be attached?

No lower than 50 mm below the top-most surface of the front hoop Signup and view all the answers

What is required if the front hoop is inclined more than 10° to the rear?

Additional bracing extending rearwards Signup and view all the answers

What type of joints are prohibited in mechanically attached roll hoop bracing?

Spherical rod ends Signup and view all the answers

What is the minimum thickness required for lugs in a double-lug joint?

4.5 mm Signup and view all the answers

What is the minimum metric grade required for pins or bolts in mechanically attached roll hoop bracing?

8.8 Signup and view all the answers

Competition Document Submission Guidelines

Choose a study mode

Podcast

Questions and Answers