Switch Management and Duplex Communication Quiz

Play an AI-generated podcast conversation about this lesson

What must be configured on a switch to enable remote management access?

DNS server and subnet mask

MAC address and subnet mask

IP address and subnet mask (correct)

Default gateway and VLAN

What is the impact of full-duplex communication on bandwidth efficiency?

It causes network congestion

It has no impact on bandwidth efficiency

It increases bandwidth efficiency (correct)

It decreases bandwidth efficiency

What characterizes a micro segmented LAN?

It uses hubs for network connectivity

It operates in half-duplex mode

It requires collision detection circuits

It has multiple devices connected to a switch port (correct)

What is required for Gigabit Ethernet and 10 Gb NICs to operate?

Full-duplex connections Signup and view all the answers

What is the purpose of auto-MDIX in a switch interface?

To automatically detect and configure the required cable connection type Signup and view all the answers

When connecting to switches without auto-MDIX, which type of cable must be used?

Straight-through cables Signup and view all the answers

What command is used to verify that a switch has been correctly configured?

show running-config Signup and view all the answers

What does the 'line protocol is up' status indicate in the output of the show interfaces command?

The interface is operational Signup and view all the answers

What must be set to 'auto' when using auto-MDIX on a switch interface?

Interface speed and duplex Signup and view all the answers

What does the 'mdix auto' command enable on newer Cisco switches?

Auto-MDIX feature Signup and view all the answers

Switch Management and Duplex Communication Quiz

Podcast Beta

Questions and Answers

What must be configured on a switch to enable remote management access?

What is the impact of full-duplex communication on bandwidth efficiency?

What characterizes a micro segmented LAN?

What is required for Gigabit Ethernet and 10 Gb NICs to operate?

What is the purpose of auto-MDIX in a switch interface?

When connecting to switches without auto-MDIX, which type of cable must be used?

What command is used to verify that a switch has been correctly configured?

What does the 'line protocol is up' status indicate in the output of the show interfaces command?

What must be set to 'auto' when using auto-MDIX on a switch interface?

What does the 'mdix auto' command enable on newer Cisco switches?

More Quizzes Like This

Server and Switch Room Design Guidelines Quiz

4_3_3 Section 4 – Operations and Incident Response - 4.3 – Investigati...

Configuring Switch with Initial Settings

Networking Basics Switch Functionality

Upgrade to continue