Summative Exam 3 Practice Test
15 Questions
1 Views

Choose a study mode

Play Quiz
Study Flashcards
Spaced Repetition
Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

What is the cutoff frequency of the circuit in the given figure?

  • 0 Hz
  • 21 Hz
  • 60 Hz
  • 365 Hz (correct)

What is the resistance of the resistor in a circuit if the admittance is given as (0.040 + 𝑗0.025)𝑆?

  • 9 ohms
  • 25 ohms
  • 12.5 ohms
  • 18 ohms (correct)

What is the phasor voltage V_AB (in volts) in the AC network shown in the figure?

  • 0
  • 17∠30° (correct)
  • 5∠30°
  • 12.5∠30°

What is the approximate total reactance when a voltage with a frequency of 7 kHz is applied across the circuit terminals with two 10 H inductors in parallel and a third 10 H inductor in series?

<p>660 kΩ (B)</p> Signup and view all the answers

Calculate the bandwidth of a filter constructed from a coil having 100 mH inductance and 30 ohms series resistance in parallel with a 0.8 uF capacitor.

<p>47.75 Hz (B)</p> Signup and view all the answers

What will be the wavelength of the signal emitted by a GaAs diode?

<p>869 nm (C)</p> Signup and view all the answers

What is the reverse saturation current at 40°C for the same bias in a silicon (PN) junction with a reverse saturation current of 10 pico Ampere at 20°C?

<p>30 pA (C)</p> Signup and view all the answers

In a series RLC circuit with a resonance frequency of 1 kHz and a quality factor Q = 100, if each of R, L, and C is doubled from its original value, what is the new Q of the circuit?

<p>200 (A)</p> Signup and view all the answers

What is the voltage available from the diode voltage doubler if the secondary voltage of the transformer connected to its input is 120 V (rms)?

<p>240 V (D)</p> Signup and view all the answers

In the circuit shown in the figure, A1, A2, and A3 are ideal ammeters. If A1 reads 5 A and A2 reads 12 A, what should A3 read?

<p>13 A (D)</p> Signup and view all the answers

Determine the total current in the circuit shown in the figure.

<p>6.67 A (D)</p> Signup and view all the answers

In the given circuit, what does IT equal to?

<p>1.5 A (A)</p> Signup and view all the answers

Which of the following does not result from adding an acceptor impurity?

<p>The substance has an electron surplus. (C)</p> Signup and view all the answers

What is the type of filter shown in the figure?

<p>Low pass filter (B)</p> Signup and view all the answers

What is the peak factor of a sine waveform?

<p>1.414 (C)</p> Signup and view all the answers

Flashcards

Cutoff Frequency

The frequency at which the circuit's output signal is reduced by 3 dB compared to its maximum value.

Resistance from Admittance

The reciprocal of the admittance, measured in ohms.

Phasor Voltage V_AB

The voltage across the points A and B in the circuit, represented as a complex number with magnitude and angle.

Total Reactance (Inductive Circuit)

The total opposition offered by the circuit to the flow of alternating current. In this case, it is the combination of the reactances of the inductors.

Signup and view all the flashcards

Bandwidth of a Filter

The range of frequencies for which a filter allows signals to pass through with minimal attenuation. It is measured in Hertz.

Signup and view all the flashcards

Wavelength of a Signal

The distance a wave travels in one period of its oscillation. This is calculated using the speed of light and the energy of the emitted photons.

Signup and view all the flashcards

Reverse Saturation Current

The reverse current that flows across a PN junction when it is reverse biased. Its value changes with temperature and can be calculated using the equation: I_R(T2) = I_R(T1) * exp((T2-T1)/(10))}

Signup and view all the flashcards

Quality Factor (Q)

A measure of how sharply tuned a resonant circuit is or how well it can discriminate between the resonant frequency and other frequencies.

Signup and view all the flashcards

Diode Voltage Doubler Circuit

A circuit that doubles the voltage of an AC source. The output voltage is twice the peak voltage of the input.

Signup and view all the flashcards

Total Current in a Parallel Circuit

The total current flowing through the circuit is the sum of the currents through the three branches.

Signup and view all the flashcards

Total Current (IT)

The total current in a circuit with multiple branches.

Signup and view all the flashcards

Acceptor Impurity

A type of impurity atom that increases the number of holes in a semiconductor. For example, Boron is an acceptor impurity to silicon.

Signup and view all the flashcards

Low Pass Filter

A type of filter circuit that allows low-frequency signals to pass through while attenuating high-frequency signals.

Signup and view all the flashcards

Peak Factor

The ratio of the peak value of a waveform to its RMS value.

Signup and view all the flashcards

More Like This

Circuit Analysis Steps
5 questions

Circuit Analysis Steps

AstonishingSodalite avatar
AstonishingSodalite
Circuit Analysis Quiz
10 questions

Circuit Analysis Quiz

GoodlyHeisenberg1547 avatar
GoodlyHeisenberg1547
Circuit Analysis Fundamentals
13 questions

Circuit Analysis Fundamentals

MomentousJadeite8521 avatar
MomentousJadeite8521
Use Quizgecko on...
Browser
Browser