Service Tap Procedures Quiz

Play an AI-generated podcast conversation about this lesson

Which valve should be installed pointing down during the service tap procedure?

Main Valve

Bypass Valve (correct)

Flop Valve

Relief Valve

Where should the lower bell of the machine be placed during the service tap procedure?

On the bore bar

On the relief valve

On the main

On the saddle (correct)

What should be done to remove any kinks in the chain during the service tap procedure?

Install chain and hand tighten

Tighten until secure

Tap on the chain (correct)

Loosen hook nuts

When should the drill/tap be installed onto the boring bar during the service tap procedure?

After filling with water Signup and view all the answers

What should be done to ensure that the tap is firmly started during the service tap procedure?

Remove yoke once tap is firmly started Signup and view all the answers

When should the bore bar be extracted fully during the service tap procedure?

After closing the flop valve Signup and view all the answers

What should be done after the bore bar is extracted fully during the service tap procedure?

Close the flop valve and open the relief valve Signup and view all the answers

When should the top section of the machine be removed during the service tap procedure?

After drilling the hole Signup and view all the answers

What should be done with the tap after removing and cleaning it during the service tap procedure?

Store in a container Signup and view all the answers

Which step should be taken after applying teflon tape or thread sealant to the corp?

Close the Corp Signup and view all the answers

What should be done after opening the bypass valve?

Open and lock the flop valve Signup and view all the answers

What should be done after locking the yoke and threading until Corp is secure?

Remove the yoke Signup and view all the answers

What should be done after threading Corp into main?

Open the relief valve to release pressure Signup and view all the answers

What should be done if there are leaks after opening the relief valve?

Tighten Corp more Signup and view all the answers

What should be done after removing the chain?

Lower the section of the machine and saddle Signup and view all the answers

What should be done after using a wrench to remove the lower cap?

Clean up and store the tapping machine for next use Signup and view all the answers

What should be done after cleaning up and storing the tapping machine for next use?

Apply teflon tape or thread sealant to Corp Signup and view all the answers

What should be done before applying teflon tape or thread sealant to Corp?