Podcast
Questions and Answers
Which solver is the default program chosen for the analysis settings?
Which solver is the default program chosen for the analysis settings?
- Sparse solver
- PCG solver
- Iterative solver
- Direct solver (correct)
What does the 'Step Controls' setting in the analysis settings allow you to specify?
What does the 'Step Controls' setting in the analysis settings allow you to specify?
- Both number of steps and end time for each step (correct)
- End time for each step
- Number of steps in an analysis
- Neither number of steps nor end time for each step
What is the purpose of 'Weak springs' in the analysis settings?
What is the purpose of 'Weak springs' in the analysis settings?
- To determine large deflection
- To anticipate underconstrained models (correct)
- To control pivot checking
- To solve ill conditioned solver matrices
What happens if an ill conditioned solver matrix is encountered in the analysis settings?
What happens if an ill conditioned solver matrix is encountered in the analysis settings?
What does the 'Large Deflection' setting determine in the analysis settings?
What does the 'Large Deflection' setting determine in the analysis settings?
Which type of analysis is the focus of Workshop 2: Mechanical Basics?
Which type of analysis is the focus of Workshop 2: Mechanical Basics?
What can be requested before or after solving in Ansys Mechanical?
What can be requested before or after solving in Ansys Mechanical?
How can you evaluate all results in Ansys Mechanical?
How can you evaluate all results in Ansys Mechanical?
What types of structural results are available in Ansys Mechanical?
What types of structural results are available in Ansys Mechanical?
What are contour and vector plots usually shown on in Ansys Mechanical?
What are contour and vector plots usually shown on in Ansys Mechanical?
Which technique is the focus of Workshop 01: Named Selections Introduction to Ansys Mechanical?
Which technique is the focus of Workshop 01: Named Selections Introduction to Ansys Mechanical?
What is the purpose of the two holes at one end of the model in Workshop 01?
What is the purpose of the two holes at one end of the model in Workshop 01?
What effect does the radial displacement simulate in Workshop 01?
What effect does the radial displacement simulate in Workshop 01?
What file should be opened at the beginning of Workshop 01?
What file should be opened at the beginning of Workshop 01?
What warning message might be encountered when opening the file for Workshop 01?
What warning message might be encountered when opening the file for Workshop 01?
