ECAM System Symbols and Fire Valve Status

Play an AI-generated podcast conversation about this lesson

What must be done before performing the retraction process again?

Put the STOW/RESET switch to the STOW position

Align the index marks of the hub with the index marks on the leg (correct)

Press the warm up flow indicator in

Check the cover plate for ground test equipment

What is the purpose of putting the STOW/RESET switch to the RESET position before retraction?

To activate the warm flow indicator

To turn off all power sources

To reset the interlock logic in the stow panel (correct)

To initiate a backup system

What indicates that the RAT (Ram Air Turbine) is in the correct position for retraction?

The warm flow indicator is off

The cover plate lamp test is successful

The RAT safety device is installed

The leg position is greater than 10° (correct)

What should be done to prevent accidental deployment of the RAT?

Install a safety device Signup and view all the answers

What does pressing the warm up flow indicator in signify in the process?

Starting a warm-up cycle Signup and view all the answers

What action should be taken with the STOW/RESET switch to prepare for retraction?

Set it to STOW position Signup and view all the answers

Which indication confirms that the RAT is stowed and ready for maintenance?

OFF position arrows on the cover plate Signup and view all the answers

What is a crucial step before aligning index marks of the hub with those on the leg?

Ensure all power sources are turned off Signup and view all the answers

Why should you install a safety device near the RAT?

To avoid accidental deployment Signup and view all the answers

What is an important task after aligning index marks of the hub with those on the leg?

Resetting interlock logic with STOW/RESET switch Signup and view all the answers

ECAM System Symbols and Fire Valve Status

Podcast Beta

Questions and Answers

What must be done before performing the retraction process again?

What is the purpose of putting the STOW/RESET switch to the RESET position before retraction?

What indicates that the RAT (Ram Air Turbine) is in the correct position for retraction?

What should be done to prevent accidental deployment of the RAT?

What does pressing the warm up flow indicator in signify in the process?

What action should be taken with the STOW/RESET switch to prepare for retraction?

Which indication confirms that the RAT is stowed and ready for maintenance?

What is a crucial step before aligning index marks of the hub with those on the leg?

Why should you install a safety device near the RAT?

What is an important task after aligning index marks of the hub with those on the leg?

More Quizzes Like This

ECAM Display Management System Quiz

A320 SDAC Quiz: Identify ECAM Messages with Flashcards

ECAM EICAS Quiz and Flashcards: Aircraft Monitoring Systems

ECAM Test Quiz: Aircraft Advisory Mode Insights

Upgrade to continue