Automatic Transmission Diagnosis and Maintenance Quiz

What is the purpose of a stall test?

What is the recommended method to locate a leak from an automatic transmission?

What could be the reason for the torque converter clutch not applying?

What do range charts indicate?

How is pressure testing performed on an automatic transmission/transaxle?

What is the purpose of separating the torque converter from the engine drive flex plate?

When is using a scan tool helpful?

What should be done before removing the pan from the transmission/transaxle?

What could be other possible causes of poor performance or sluggish acceleration besides a fault with the automatic transmission/transaxle?

What is the recommended method to flush ATF?

What should be checked before adjusting the linkage between the shift selector and automatic transmission?

Identifying the transmission/transaxle can be challenging and requires checking service information.
A stall test is performed to verify the proper operation of the torque converter.
To locate a leak from an automatic transmission/transaxle, perform a visual inspection and use dye testing if necessary.
The torque converter clutch may not be applying due to a fault in the computer sensors, wiring, or the TCC solenoid.
Range charts indicate which holding device is used for each gear selection in a vehicle.
Pressure testing involves connecting a pressure gauge to pressure taps located on the outside of the automatic transmission/transaxle.
Separating the torque converter from the engine drive flex plate can help diagnose vibrations.
Using a scan tool is helpful when diagnosing automatic transmission problems.
Proper procedures should be followed when removing the pan from the transmission/transaxle.
Many possible causes of poor performance or sluggish acceleration exist besides a fault with the automatic transmission/transaxle.
Steps to remove and inspect automatic transmission fluid (ATF) pan
Use protective clothing and avoid contact with hot fluid
Inspect pan for excessive friction material and wear metals
Use a magnet to check for steel particles indicating severe wear
Filter replacement is recommended and can cause problems if not done correctly
Flushing ATF can be done through different methods
Proper operation of electronically controlled automatic transmission/transaxle depends on electrical power
Use a headlight to check for enough current being sent to the unit
Adjust linkage between shift selector and automatic transmission when necessary
Check engine and transmission/transaxle mounts before adjusting linkage

Are you an expert in automatic transmission and transaxle systems? Test your knowledge with this quiz that covers topics such as identifying transmission types, stall testing, leak detection, torque converter clutch issues, pressure testing, and more. Learn about proper procedures for removing the pan and inspecting fluid, as well as the importance of filter replacement and flushing methods. Additionally, discover the significance of electrical power and linkage adjustments in the proper operation of electronically controlled systems. Take this quiz and see how much you know about