Pipe & Excavation Practice Questions PDF
Document Details
Uploaded by IndustriousCalifornium7567
Tags
Summary
This document contains a collection of questions and answers related to pipe and excavation. The topic involves various aspects of civil engineering, construction, and the different materials and methods involved in excavation projects.
Full Transcript
Pipe & Excavation 1\. (\#10749) - A 100% slope is the same as a? Answer: 45 degree angle Pipe & Excavation - 80 2\. (\#14090) - A bid is being prepared for a project with high groundwater. All of the statements are true and should be considered in the bid EXCEPT Answer: Wellpoint dewatering...
Pipe & Excavation 1\. (\#10749) - A 100% slope is the same as a? Answer: 45 degree angle Pipe & Excavation - 80 2\. (\#14090) - A bid is being prepared for a project with high groundwater. All of the statements are true and should be considered in the bid EXCEPT Answer: Wellpoint dewatering systems are the most effective in fine grain-soils Pipe & Excavation - 296 3\. (\#751) - A downhill slope is a: Answer: Negative grade Pipe & Excavation - 80 4\. (\#10751) - Adequate boosting will allow scrapers to spread the soil remaining in front of the bowl as its? Answer: Lifted Pipe & Excavation - 93 5\. (\#14088) - An advantage of nuclear compaction test compared to other methods is that? Answer: It does not require the removal of the soil samples from the site of the test Pipe & Excavation - 186 6\. (\#10754) - Coarse-grained soils (like gravel) tend to withstand? Answer: Saturation Pipe & Excavation - 187 7\. (\#743) - If you are working a job that has silt or clay soil that has become saturated and compaction is an issue, what should you do? Answer: Haul it away and replace it with dry soil Pipe & Excavation - 291 8\. (\#724) - The easiest type of rock to rip is: Answer: Sedimentary Pipe & Excavation - 279 9\. (\#14086) - The optimum hourly production rate is 700 loose cubic yards when working in soil with a 35 percent swell factor. What is the adjusted production rate in bank cubic yards? (Pipe) Answer: 519 1/8/25, 10:32 AM Contractor Courses https://contractorcourses.com/my-courses/course/100/north-carolina-residential/featured-questions 8/38 Pipe & Excavation - 66 - Figure 2-5 10\. (\#744) - What do contour lines show? Answer: A contour line represents points of equal elevation above or below an arbitrary reference Pipe & Excavation - 257 11\. (\#730) - What dozing technique reduces the amount of the load lost during transit? Answer: Slot dozing Pipe & Excavation - 81 12\. (\#14085) - What is the average cycle time for a wheeled backhoe (14-foot hoe) digging an 8-foot trench in hardpan? Answer: 18 seconds Pipe & Excavation - 65 - Fig 2-3 13\. (\#731) - What is the best piece of equipment to dig a trench in soft soil? Answer: Tracked backhoe Pipe & Excavation - 174 14\. (\#723) - When positioning a trench box it is always centered over the pipe. To maintain safety in the ditch, the maximum height above the pipe you should install a trench box is: Answer: 5 feet Pipe & Excavation - 174 15\. (\#765) - Which of the below would be used for excavating shallow trenches with cross lines? Answer: Wheeled / Rubber tire backhoe Pipe & Excavation - 152 - Figure 5-9 16\. (\#14089) - Which of the following materials will reduce dozer production rates the most? Answer: Fine-grained igneous rock Pipe & Excavation - 276 17\. (\#14087) - Which statement is true about the impact of soils structure and density and the choice of compaction methods to maximize production? Answer: Course sand and gravel compact well with water and vibration Pipe & Excavation - 186 18\. (\#16680) - When installing a thrust block on a 8 inch pipe carrying 100 psi with a 45 degree fitting and the elbow bearing against sand what is the thrust block surface area? Answer: 4.1 Sqft Pipe & Excavation - 197 19\. (\#16830) - What is the maximum angle of repose for average soils? 1/8/25, 10:32 AM Contractor Courses https://contractorcourses.com/my-courses/course/100/north-carolina-residential/featured-questions 9/38 Answer: 1:1 Pipe & Excavation - 171 20\. (\#16831) - What is the recommended slope for average soils? Answer: 45 degree Pipe & Excavation - 171 21\. (\#17343) - What do contour lines on a topographical map that form a closed loop represent? Answer: Summit or Depression Pipe & Excavation - 258 22\. (\#17344) - On a topographical map what is indicated by contour lines that are closer together? Answer: Increase in slope Pipe & Excavation - 258 23\. (\#17345) - What type of slope is indicated by contour lines that are closer at the peak of the slope than at the bottom? Answer: Concave Pipe & Excavation - 258 24\. (\#17426) - What type of pipe is typically used to connect at the top of a water heater? Answer: Type M copper pipe Pipe & Excavation - 299 25\. (\#17427) - What type of pipe would be used to distribute gas behind concealed walls? Answer: Black pipe Pipe & Excavation - 300 26\. (\#17700) - With silt fences, generally the maximum spacing between posts should be \_\_\_\_\_ and post depth should be at least \_\_\_\_\_. Answer: 6 feet, 12 inches Pipe & Excavation - 138 28\. (\#18669) - What should be the angle of repose for compacted sharp sand? Answer: 33° Pipe & Excavation - 171 29\. (\#19041) - What type of pipe is most commonly used for drinking water? Answer: Copper Pipe & Excavation - 298 30\. (\#19345) - What type of pipe is not primarily used for liquids, but solids? Answer: Soil pipe Pipe & Excavation - 300 31\. (\#19359) - What test is normally required for septic tank drainfields? Answer: Percolation test Pipe & Excavation - 216 Carpentry &