Qualifications of Building Officials under the National Building Code

250 millimeters

200 kilograms per square meter

120 kilograms per square meter

<p>At least one entrance and one exit</p> Signup and view all the answers

<p>Conform to the Philippine Electrical Code</p> Signup and view all the answers

<p>750 millimeters</p> Signup and view all the answers

<ol> <li>Filipino citizen and of good moral character, 2. Duly registered architect or civil engineer, 3. Member of good standing of a duly accredited organization for at least two years, 4. Has at least five years of professional experience in building design and construction</li> </ol> Signup and view all the answers

<p>Enforcement of the provisions of the National Building Code and its implementing rules and regulations, Issuing building permits</p> Signup and view all the answers

<p>Enter any building or its premises at all reasonable times to inspect and determine compliance with the requirements of the Code</p> Signup and view all the answers

<p>Until regular positions of Building Official are provided or unless sooner terminated for causes provided by law or decree</p> Signup and view all the answers

<p>At least five years of diversified and professional experience in building design and construction</p> Signup and view all the answers

<p>Termination can occur if regular positions of Building Official are provided or for causes provided by law or decree</p> Signup and view all the answers

<p>600 millimeters square or 600 millimeters in diameter</p> Signup and view all the answers

<p>800 millimeters</p> Signup and view all the answers

<p>Into horizontal areas not exceeding 250 square meters by fire-resistive partitions</p> Signup and view all the answers

<p>When the entire attic is equipped with an approved automatic fire-extinguishing system</p> Signup and view all the answers

<p>Self-closing doors</p> Signup and view all the answers

<p>Between roof and bottom chords or trusses</p> Signup and view all the answers

<p>Its own weight and the vertical dead load of veneer immediately above.</p> Signup and view all the answers

<p>The additional vertical and lateral loads imposed by the veneer.</p> Signup and view all the answers

<p>Differential movements of the supports including those caused by temperature changes, shrinkage, creep, and deflection.</p> Signup and view all the answers

<p>To have a bond to the supporting elements sufficient to withstand shearing stresses due to their weights including seismic effects on the total assemblage.</p> Signup and view all the answers

<p>Horizontal forces equal to twice the weight of the veneer.</p> Signup and view all the answers

<p>They should be non-combustible and corrosion-resistant.</p> Signup and view all the answers

<p>An enclosure will not be required for a stairway, ramp, or escalator serving only one adjacent floor and not connected with corridors or stairways serving other floors, except in Group D Occupancies.</p> Signup and view all the answers

<p>The enclosure walls shall not be less than two-hour fire-resistive construction.</p> Signup and view all the answers

<p>The only openings allowed in exit enclosures are exit doorways and openings in exterior walls.</p> Signup and view all the answers

<p>Stairway and ramp enclosures shall include landings and parts of floors connecting stairway flights, and shall include a corridor on the ground floor leading from the stairway to the exterior of the building.</p> Signup and view all the answers

<p>If a stairway in an exit enclosure continues below the grade level exit, an approved barrier must be provided at the ground floor level to prevent persons from accidentally continuing into the basement.</p> Signup and view all the answers

<p>There shall be no enclosed usable space under stairways in an exit enclosure, nor shall the open space under such stairways be used for any purpose.</p> Signup and view all the answers