Medical Device Maintenance and Inspection

What is the primary reason for returning an entire load for re-processing?

A small percentage of RMD in the load were not cleaned and/or dried effectively. (correct)

All items in the load were not processed in a WD.

The load was not properly documented.

There is visible soil or staining on all items in the load.

What is the purpose of manually inspecting devices under magnification?

To verify the completion of device sets.

To detect small pieces of bioburden or debris. (correct)

To ensure all devices are properly disassembled.

To check for corrosion and breakage.

What is the primary purpose of function testing devices?

To check for damage or malfunction. (correct)

To verify the cleanliness of devices.

To ensure all devices are properly disassembled.

To confirm the completion of device sets.

What is the purpose of a diathermy pin point tester in inspecting devices?

To ensure the insulation of devices remains intact Signup and view all the answers

What is the primary function of a computerized track and trace system in a CSSD?

To accurately track devices and device trays through the decontamination process Signup and view all the answers

What should be done if a device is damaged or malfunctioning during inspection?

Report the issue to the line manager immediately. Signup and view all the answers

What should be checked on jointed RMD during the inspection process?

The tightness of the screws Signup and view all the answers

What is the purpose of documenting manually cleaned items and non-conformances?

To track the cleaning process for quality control. Signup and view all the answers

What is the result of scanning a barcode label in a computerized track and trace system?

A unique barcode label is generated with a specific serial number Signup and view all the answers

What is the alternative to a computerized track and trace system in a CSSD?

A manual system with a pre-printed tray checklist Signup and view all the answers

What could be the cause of excessive wetness in the load?

Blocked arms Signup and view all the answers

What should be done if a device was not properly disassembled before cleaning?

Return the entire tray for reprocessing Signup and view all the answers

Which issue necessitates the entire load to be returned for re-processing?

Spray arm rotation hindered Signup and view all the answers

What should be checked during the final inspection of the load?

Ensure there's no obvious damage, staining, or residue Signup and view all the answers

What actions should be taken if staining or residue is present after cycle completion?

Send the load back for reprocessing Signup and view all the answers