Mastering Bandwidth SLA

Play an AI-generated podcast conversation about this lesson

Which protocol is most commonly used for securing IP communications in SD-WAN overlays?

IPsec (correct)

TCP

IKE

UDP

What is the default UDP port used by IKE for the handshake, tunnel maintenance, and disconnection in IPsec?

UDP 1000

UDP 500 (correct)

UDP 2000

UDP 4500

Which protocol in the IPsec suite provides data integrity and encryption?

ESP (correct)

IKE

UDP

TCP

What IP protocol number does ESP use for ensuring data integrity and encryption in IPsec?

IP proto 50 Signup and view all the answers

What is the purpose of NAT transversal (NAT-T) in IPsec?

To handle NAT traversal Signup and view all the answers

Which UDP port is used by ESP when NAT-T is enabled in IPsec?

UDP 4500 Signup and view all the answers

What happens to IKE negotiation when NAT is detected along the path in IPsec?

It switches to using UDP port 4500 Signup and view all the answers

What is the effect of setting minimum-sla-meet-members to 0 in FortiGate?

The rule remains active Signup and view all the answers

What is the effect of setting minimum-sla-meet-members to 2 in FortiGate?

The rule remains active Signup and view all the answers

What is the effect of setting minimum-sla-meet-members to 3 in FortiGate?

The rule is disabled and skipped Signup and view all the answers

Which rule mode supports defining the minimum number of members that must meet at least one of the SLA targets configured in a rule?

Both lowest cost SLA and maximise bandwidth SLA Signup and view all the answers

What is the default value for the setting 'minimum-sla-meet-members'?

0 Signup and view all the answers

In the first example on the slide, why is T_MPLS the only preferred member?

Because it meets the most SLA targets Signup and view all the answers

In the second example on the slide, why are sessions load balanced across all members?

Because all members have the same SLA status Signup and view all the answers

What is the purpose of the 'minimum-sla-meet-members' setting?

To define the minimum number of members that must meet at least one SLA target Signup and view all the answers

Which rule mode is the 'minimum-sla-meet-members' setting supported by?

Both lowest cost SLA and maximise bandwidth SLA Signup and view all the answers

What happens if the number of members that meet the SLA is below the minimum threshold?

The rule is disabled and skipped during the rule matching stage Signup and view all the answers

What is the purpose of the 'maximum bandwidth SLA' rule mode?

To ensure minimum bandwidth for a service Signup and view all the answers

What is the CLI configuration command to set the 'minimum-sla-meet-members' value?

set minimum-sla-meet-members Signup and view all the answers

What is the default value for the 'minimum-sla-meet-members' setting?