Logistics Procedures Quiz

When turning in items, which PAF form is used for the Turn In procedure?

How many copies of F-1348 are raised during a demand procedure?

When an unserviceable (u/s) item is turned in to the logistics squadron, how many copies of the F-1348 form are used?

Upon promotion to Senior Technician, supervision duties are required. In which group does the initial issue of TMA take place?

Unfriendly countries broadcasting content with the aim of subverting Pakistanis is known as what?

When an inventory holder goes on leave, who ultimately decides how the inventory is handed over?

How quickly should duplicate copies of issue/turn-in vouchers be delivered to EAS after a transaction at Log Sqn?

What is Form 37 primarily used for?

How many copies of Sheet 1 of Form 37 are initially created?

How many copies of Sheet 2 of Form 37 are generated?

Which copy of AF Form 48 is sent to the user agency to confirm that requested work has commenced?

What is the designation for the System/Equipment Status Record form?

Regarding equipment with specific inspection needs, is a separate AFTO Form 244 required?

When working with RJ-45, RJ-9 and RJ-11 connectors simultaneously on a job, what is the MOST efficient tool management strategy?

Considering the functionality of a Digital Multimeter (DMM), what would be the MOST appropriate procedure when measuring an unknown voltage in an electrical circuit?

If a Fluke 177 DMM consistently displays fluctuating and inaccurate readings, what is the MOST likely cause considering the tool's power source?

When performing earth resistance measurements, what is the SIGNIFICANCE of using a longer green test lead compared to the other leads?

Which statement BEST describes the functional relationship between an earth tester's measurements and the safety of an electrical installation?

Why are areas of high power density often fenced off or made inaccessible during transmission?

What is the primary purpose of walkways, foot rails, and handrails provided on the exterior of structures?

What should maintenance personnel confirm after switching equipment on?

What is the significance of understanding the potential effects of fluids and oils used with equipment?

Why should equipment trailers/cabins NOT be positioned directly in line with the prevailing wind direction, without compromising operational effectiveness?

Which network device operates primarily at the Data Link Layer (Layer 2) of the OSI model, using MAC addresses to forward data?

If a Moxa server has a maximum power rating, and a technician measures that it is consistently drawing 85 Watts under peak load, what is a safe wattage rating to assume for power supply planning?

A control power supply is designed to operate in regions with different voltage standards. Which input voltage range would be most suitable for global compatibility?

In an inverter portion, the input voltage is measured to be approximately 405 VDC. Is this within the expected operating range according to given standards?

Given a network configuration using the 192.168.X.0 subnet, which of the following IP addresses is most likely assigned to a router acting as the default gateway?

In a communication system utilizing GMCC and SMCC, which networking device is responsible for facilitating data exchange between these components?

A network technician needs to connect several devices using a 4305 router. What is the maximum number of wired devices that can be directly connected to this router?

When transmitting data through a SOC (System on Chip), how many dedicated output channels are utilized for transmitting data?

During diagnostic testing, a technician observes that a valid MPDR data signal exhibits a brief light flicker. What minimum duration of light flicker confirms the presence of the reference pulse?

What crucial step should be taken if the antenna tripod is on uneven ground before operation?

During GB208 operation, what immediate action should be taken if no transmission is occurring?

Which instrument is appropriate to test the earthing?

What could be the reason if the PTT key remains dark during operation?

In the event of no reception on GB 208 during operation, what initial steps should be considered?

What is the likely consequence if the antenna is not balanced on its tripod?

During operation of the GB 208, if the PTT key remains dark and unresponsive after the initial check, what next step should be considered?

What describes the relationship between proper earthing and the equipment's operation?