Podcast
Questions and Answers
The ______ used for the experiment is not perfectly isotropic.
The ______ used for the experiment is not perfectly isotropic.
sheet metal
Material fracture occurs based on the ______ concentration of vulnerable areas.
Material fracture occurs based on the ______ concentration of vulnerable areas.
stress
The units of the ______ properties need to be maintained during simulation.
The units of the ______ properties need to be maintained during simulation.
material
The ______ stress distribution is an important factor in stress and strain analysis.
The ______ stress distribution is an important factor in stress and strain analysis.
The blank is heated prior to Incremental Sheet Forming at a temperature below the ______ temperature of the material.
The blank is heated prior to Incremental Sheet Forming at a temperature below the ______ temperature of the material.
Material selection for ______ container manufacturing is crucial for product quality.
Material selection for ______ container manufacturing is crucial for product quality.
Ceramics have high ______ and stiffness because of their atomic bonds, making them resistant to deformation and low strain.
Ceramics have high ______ and stiffness because of their atomic bonds, making them resistant to deformation and low strain.
Stress and strain increase with ______; atoms vibrate more with higher temperatures making materials prone to plasticity.
Stress and strain increase with ______; atoms vibrate more with higher temperatures making materials prone to plasticity.
This is an important consideration when selecting ______ temperatures.
This is an important consideration when selecting ______ temperatures.
The ______ stress distribution has higher values in the polymer and lower values in the ceramic.
The ______ stress distribution has higher values in the polymer and lower values in the ceramic.
It is important to know when a material will ______ or fail.
It is important to know when a material will ______ or fail.
The stress and strain values from the contour plots are lowest for the ______ material.
The stress and strain values from the contour plots are lowest for the ______ material.
In ABAQUS, the ______ stress is a scalar stress value used for ductile failure criteria.
In ABAQUS, the ______ stress is a scalar stress value used for ductile failure criteria.
Aluminum alloys are commonly used for manufacturing beverage containers due to their ______ properties.
Aluminum alloys are commonly used for manufacturing beverage containers due to their ______ properties.
When analyzing the stress distribution in a beverage container, the ______ stress component is often of interest.
When analyzing the stress distribution in a beverage container, the ______ stress component is often of interest.
The increase in internal pressure of a beverage container from 20°C to 57°C is due to the ______ behavior of gases.
The increase in internal pressure of a beverage container from 20°C to 57°C is due to the ______ behavior of gases.
In ABAQUS, the ______ module is used to create and edit part geometries.
In ABAQUS, the ______ module is used to create and edit part geometries.
Performing a ______ check in ABAQUS is important to identify and correct any errors before running a simulation.
Performing a ______ check in ABAQUS is important to identify and correct any errors before running a simulation.
Flashcards are hidden until you start studying
