Podcast
Questions and Answers
What is the purpose of a weep hole on an antenna or radome?
What is the purpose of a weep hole on an antenna or radome?
- To allow air to flow in and out of the antenna or radome
- To protect the antenna or radome from dust and debris
- To drain water that accumulates inside the antenna or radome (correct)
- To increase the signal strength of the antenna or radome
When should a cat5e or coax cable be tested?
When should a cat5e or coax cable be tested?
- Only when a new fitting or connector is added (correct)
- Only when there is packet loss between MBU and radio
- Anytime a new or used patch cable is used
- Only when a customer is receiving less than 100mbps
What is the default IP address of an Aviat?
What is the default IP address of an Aviat?
- 192.168.0.1
- 192.168.1.10
- 192.168.1.1 (correct)
- 10.10.1.1
What is the purpose of 'clear grease' on an Aviat?
What is the purpose of 'clear grease' on an Aviat?
What is the minimum pole size required for a Siklu or Aviat mounting bracket?
What is the minimum pole size required for a Siklu or Aviat mounting bracket?
What is the average time for a Siklu unit to boot up when powering up or rebooting?
What is the average time for a Siklu unit to boot up when powering up or rebooting?
What is the purpose of the Siklu RF LED color indicator and what color does it turn when indicating the radio is in alignment mode?
What is the purpose of the Siklu RF LED color indicator and what color does it turn when indicating the radio is in alignment mode?
When assembling an Aviat, what is a common mistake that technicians make with the Polarization Puck?
When assembling an Aviat, what is a common mistake that technicians make with the Polarization Puck?
What should technicians check if they are not getting any reading on their voltmeter after plugging it into an Aviat?
What should technicians check if they are not getting any reading on their voltmeter after plugging it into an Aviat?
How many adjustments are typically required by each technician on the remote and local site to achieve target RSSI in a radio?
How many adjustments are typically required by each technician on the remote and local site to achieve target RSSI in a radio?
