Ch 18 pg 468-473

Where smoke is reported on several floors get off __ floors below the lowest reported. Make sure you know what floors contain ____ stairs

If the fire is within _ floors of the elevator lobby or sky lobby walk up

Ensure that each unit that enters a elevator has its ___ number, unit and ____ recorded by a ff who is designated ____ control

Each team that enter an elevator should have forcible entry tools and a ____ radio as well as have their SCBA turned ___

Upon entering a car immediately hit the ____ button to eliminate any selections previously made

Use only firefighter ____ elevators which are placed in proper operation by a key or other secure means

The most important point to make about ff service elevators are that they are not ____, totally safe devices

____ or service elevators don’t make good elevators to use since they usually serve every floor

A large number of serious fires start in accumulated _____ in freight elevator lobbies

As soon as the car begins to move from the lobby, press the ____ stop button

The trip up to the two floors below fire floor should consist of stops every __ floors

Stopping every 5 floors allows you to verify the elevator is still responding and it allows you to step out and verify the location of the nearest ____ stairway

If there is smoke on the floor descend __ floors and try again

If the hall is clear ensure you can get into the ____ before everyone exits the elevator

Don’t stand inside the car doors to hold it open, lay a length of ___ or have a member remain in the car holding the door ____ button

A member must remain with the elevator at all times because it only responds to door open from within the elevator this members title is nicknamed ____

The personnel of Atleast ___ ladder companies are needed on the fire floor and ___ truck company on the floor above to preform search and rescue and check for extension

For fires with open ceiling space and a bunch of partitions below a 2 1/2 in line with a ____ solid tip is the preferred hoseline

NFPA 14, 2016 edition states that fire pumps are only required to discharge their capacity at __ psi at the highest hose outlet and a max of ___ psi. The old standard allowed for as little as ___ psi at the top floor outlet prior to 1993

The standard class a pumper is rated to deliver ___ of its capacity at ___ psi

You need a nozzle that can put out an effective fire stream (___gpm) at as low as __ psi nozzle pressure (the 1 1/4 solid tip)

Many lightweight master stream devices can be carried by __ member up __ flights

One of the problems with lightweight master stream devices is their tendency to kick back when the stream angle is lowered to ____ degrees which is necessary for 8-9ft ceilings

The first method to securing these master stream devices is with two steel handled _____ hooks to span a door opening

You can deploy upward of ___ gpm with these lightweight master stream devices applied from the door of the fire stairs or door to the office area

It’s best to supply these portable monitor devices with ___ 2 1/2 in or larger lines. That means the second line will have to be stretched from the outlet __ floors below the fire. In this test that meant __ lengths of hose. This permitted up to 750gpm

Rescue 1 fastens two __ in shanks x _ in deep x 3/8 diameter threaded powder driven studs using a .38 cal powder driven actuated fastener. Secured with the devices ___, utility rope or tubular nylon webbing

This fastening method used is designed to provide 4,360lb of resistance in the ___ mode. This provides a ___ safety factor against the ___ lbs of nozzle reaction produced by a 1 3/4 tip flowing at 80psi

Core construction can provide floor spaces in excess of _____ square feet per floor

Prior to 1993 NFPA only required a standpipe system to supply a max of ____ gpm. In the revision that number was lowered to ___ gpm

You can use a ____ core drill or concrete cuttting ____ as a last resort to get water on fire from safe areas in an otherwise untenable area

The floor below nozzle only provides ___ to ____ gpm

The concrete core drill is a diamond tipped drill that can bore holes up to ___ in diameter

There are two styles of the concrete core drill one is _____ and the other is ____ driven, which only drills __ in holes which are to small to pass a 2 1/2 in Bresnan or other distributer

Both models require pump tank of water to cool bits, normally they are held in place with powder activated fastener and using ____nuts to hold the drill

A __ in hole is large enough for a ____ or cellar pipe

A 2 1/2 in bresnan distributer operating at ___ psi flows ___ gpm and covers a 20-25ft radius pg 473

The drilling of a ___ in floor can be done in 5 minutes

According to John t o Hagans book high rise fire and life safety, areas in excess of ____ square ft of a moderately fuel loaded area diminish the possibility of success through a direct attack

Atleast one manufacturer makes a cellar pipe that will pass through a 4 in hole that will flow ___ gpm

Fire floor descent

Elevator access

Elevator lobby safety

Elevator entry procedure

Elevator Security

Emergency Stop

Elevator control

Elevator verification

Smoke condition

Safe hall access

Door security

Elevator Operator

Ladder Companies

Hoseline Selection

Fire Pump Pressure

Standard Pumper Capacity

Nozzle Pressure

Master Stream Devices

Master Stream Device Issues

Master Stream Device Secured

Master Stream Flow

Secondary Hose Line

Rescue fastening

Fastening Method strength

Floor Space

Standpipe Standard

Drill Method/Types

Floor below nozzle capacity