Ch 19 pg 481-485

Fires in buildings under construction, renovation or demolition pose unique challenges to FFs in terms of ____, ____ load and operations

Often such flammable materials as adhesives, ____ and finishes are stored as well as ____ and ____ for temporary heating. Ample sources of ignition are present in the form of ____ and ____ tools, portable heating units and temporary ____

The fire watch is supposed to remain in the area looking for fire for __ minutes after the work has been completed. Most fires occur because of ____ such as broken fuel line to a space heater or ____ such as placing a heater to close to combustibles

The stream choice, where the fire is within reach is the ____ ____

Properly applied, a __ in solid tip will discharge more than ____ gpm over a 100ft deep floor

When using an elevated platform make sure to clear all personnel ____ the hose stream. It can dislodge items weighing more than ___ pounds, they can also dislodge ____ or shoring, precipitating collapse

Be aware that ____ regulations specify the way that such vertical openings must be protected. Often the guard around such openings is made of light ___ or even ____

When conducting site inspections Try to determine how you can reach the upper floors ____ the workday is through.

It is common practice to remove the lower ladders at night to prevent entry to upper areas by ____ and ____ playing in the area. Usually if a fire dept ladder is placed to the second floor, the remaining ladders are in place

If the fire is within reach of the depts ladders either ___ or ____ it is usually quicker and safer to make initial access off the depts ladders

Buildings higher than the reach of aerial ladders are usually provided with ___, similar to elevators. There are 2 concerns with ___. 1 they are often shut down at ___ and weekends. 2 most importantly is that there are two types one for people and one for ___ and ____

The people hoist will have a ____ position in the car—- the ____ will ride up with you. Also be aware that they are designed with specific ____ conditions in mind.

Watch out for large quantities of liquids or gases, such as o2 and acetylene or ____ for steel cutting. Particularly in colder seasons, large quantities of LP may be present. LP is used to fuel ____, ___ kettles and torches and various others

When pouring concrete in cold weather the entire building may be wrapped in ____ tarpaulins or ____ sheeting.

Fires in areas where LP gas is present should be fought with ____ streams from ____ locations

Older buildings undergoing demolition pose an extra hazard: _____ abatement. This is very common in older high rise (built before ___)

Asbestos removal is done by erecting ____ and sheet ___—lined walls around the entire area and installing ____ to remove any dust that’s created. Entry into this space often involves passing into an ____ chamber where exiting personnel undergo decontamination