Recent Lessons

Show all results for ""

Broadband Installation (Fixed Wireless Systems) Chapter 4

10 Questions

1 Views

Broadband Installation (Fixed Wireless Systems) Chapter 4

Choose a study mode

Play Quiz

Study Flashcards

Spaced Repetition

Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

What is the primary purpose of using a level during mast installation?

To measure the length of the coaxial cables
To ensure the mast is straight and properly aligned (correct)
To ensure the mast is properly grounded
To secure the cables to the mast

What is the main reason to ground the mast?

To measure the length of the coaxial cables
For safety and compliance (correct)
To secure the cables to the mast
To ensure the mast is properly aligned

What is the purpose of cable strippers in the cable installation process?

To measure the length of the coaxial cables
To secure the cables to the mast
To route cables from the mast to the CPE location
To prepare cable ends for connection (correct)

What should be done to ensure the connections are secure in outdoor installations?

Waterproof the connections (C) Signup and view all the answers

What is the purpose of accessing the CPE's configuration interface?

To configure network settings, SSID, security, etc. (A) Signup and view all the answers

What is the final step in the CPE installation process?

Verifying the functionality and signal strength of the connection (A) Signup and view all the answers

What is the main purpose of laying out and configuring the mast?

To ensure the mast is securely installed and configured for proper CPE installation (C) Signup and view all the answers

What is the purpose of minimizing bends and obstructions when routing cables?

To prevent signal loss and ensure optimal performance (C) Signup and view all the answers

What is the purpose of powering on the CPE after installation?

To test the connection to ensure proper functionality (C) Signup and view all the answers

What should be done to optimize the performance of the CPE?

Make any necessary adjustments to the configuration (D) Signup and view all the answers