11 Questions
Which act and regulations specify the procedure to be followed in the construction of a new boiler or pressure vessel in Canada?
CSA-B51
What must be done before other boilers or pressure vessels can be built using the same design?
The design must be registered
What does the Canadian Registration Number (CRN) indicate?
The province or territory that first registered the design
Which organization produces the ASME BPVC Section VII guidelines?
ASME
What is the purpose of a Certificate of Inspection?
To authorize the operation of a boiler or pressure vessel
What is the main recommendation in sub-section 101.1.3 of ASME BPVC Section VII?
To shut down the boiler if there is doubt about water level
Where can additional guidance for boiler installation and start-up be found?
National Fire Prevention Association
According to CSA-B51, who is responsible for carrying out a fabrication inspection in Canada?
An inspector employed by the regulatory authority in the province of fabrication
What is the hydrostatic testing pressure for a power boiler according to ASME BPVC 1-2015?
1 l/t times the maximum allowable working pressure
Which of the following information is included on the nameplate of a boiler or pressure vessel?
All of the above
What information is contained in a manufacturer's data report (MDR)?
All of the above
Test your knowledge on the regulations and procedures for constructing and installing new boilers and pressure vessels in Canada. Learn about the specific requirements outlined in each jurisdiction's act and regulations.
Make Your Own Quizzes and Flashcards
Convert your notes into interactive study material.
Get started for free
