BiCSi Documentation Cable Installation Checklist

Play an AI-generated podcast conversation about this lesson

What is the typical number of CAT6 cables required for IT Drops at a standard site?

29

How many CAT6 cables are needed for Camera Drops at a standard site?

8

Where should all the cables be pulled from for installation?

Network Cabinet [Back Office]

How many CAT6 cables are required for TV Display wiring at a standard site?

2 Signup and view all the answers

What kind of cable is recommended for Speaker Wiring?

18/2 Signup and view all the answers

What is the purpose of using a Scissor Lift in the speaker installation process?

To raise the Lift up to the Barjoist while suspending the Speaker on its Wire. Signup and view all the answers

How should the Hang Wire be attached to the Speaker in the installation process?

Using the Clip Connectors. Signup and view all the answers

Where should the Hang Wire be attached in relation to the Speaker location?

To the Barjoists where the Speaker is to hang. Signup and view all the answers

What is the recommended height for suspending the FOH Speakers & Subs from the Barjoists?

1' below the bottom of the Barjoists to the top of the Speaker. Signup and view all the answers

How should unnecessary slack in the Hang Wire be managed during the speaker installation?

Wrap the Hangwire around Barjoist and eliminate any slack. Signup and view all the answers

What is the significance of attaching the Hang Wire to a closed section Barjoist?

To secure the Wire using the Clip Connector. Signup and view all the answers

What type of wiring connection is recommended above the ceiling for the speaker installation?

Make wiring connections above the ceiling. Signup and view all the answers

Why is it important to be cautious when making the hole for the speaker installation?

To avoid making the hole too big. Signup and view all the answers

What should be positioned adjacent to the Speaker location during the installation process?

A Scissor Lift. Signup and view all the answers

How should the Hang Wire be secured to the Barjoist during the installation process?

Using the Clip Connector. Signup and view all the answers