Summary

This document provides guidelines for responding to carbon monoxide incidents. It outlines procedures for investigation and monitoring, including PPE and SCBA use, and determining appropriate actions based on CO levels. It also details how to inform occupants and check CO detectors.

Full Transcript

RIVERSIDE FIRE AUTHORITY FIELD OPERATING GUIDELINES CARBON MONOXIDE RESPONSE Carbon Monoxide (CO) is an odorless, colorless and tasteless gas that is deadly. It is a by-product of combustion...

RIVERSIDE FIRE AUTHORITY FIELD OPERATING GUIDELINES CARBON MONOXIDE RESPONSE Carbon Monoxide (CO) is an odorless, colorless and tasteless gas that is deadly. It is a by-product of combustion. Many appliances such as furnaces, kitchen stoves, hot water heaters, automobiles, etc., can produce carbon monoxide. When a faulty device or unusual conditions exist, carbon monoxide may be vented into areas where people are present. Carbon Monoxide poisoning may be difficult to diagnose. Its symptoms are similar to that of the flu, which may include headache, nausea, fatigue and dizzy spells for low levels and convulsions, unconsciousness, and death for high levels. INVESTIGATION  Once members arrive on the scene, they should first interview the occupant(s) outside the suspected hazard area to determine the following:  If any occupants are or have been feeling ill.  The number and location of any CO detectors which have been activated  The location of any combustion equipment or appliances. MONITORING  Take the first reading just inside the doorway to determine initial CO level. Personnel should then begin monitoring the lower levels of the building and then proceed to the higher levels.  Don PPE and SCBA before entering potential IDLH  If a reading of 35 ppm or greater is detected, the building or effected area shall be evacuated immediately and full turn out gear and SCBA shall be utilized during the investigation.  If a reading above 9 ppm and below 35 ppm is detected: o Any reading above 9 ppm shall be considered an above normal reading. o Occupant(s) shall be informed that an elevated level of CO has been detected. o If it is determined that an appliance is malfunctioning and thereby producing CO, an attempt to shut down the appliance will be made and the appropriate utilities company or repair person will be notified by the Incident Commander (IC). o Once the premises have been ventilated, use of positive pressure or passive ventilation, and the CO reading is reduced to a safe level, it may be occupied at the discretion of the IC. o Inform the occupant(s) that if the detector re-activated or they feel there may be a problem, to call 911.  If a reading of 9 ppm or less is detected: o Inform the occupant(s) that our instrument did not detect an elevated level of CO at this time. o Recommend occupant(s) check their CO detector per manufacturer’s recommendations. o Advise the occupant(s) to reset the CO detector, if applicable, according to the manufacturer’s instructions. o Inform the occupant(s) that if the detector reactivates or they feel there may be a problem, to call 911. Be sure to check attached structures.

Use Quizgecko on...
Browser
Browser