Podcast
Questions and Answers
What is the aim of the provided information and procedures?
What is the aim of the provided information and procedures?
- To provide information on how to use an X-ray generator
- To provide information about the history of X-ray generators
- To provide general information about medical equipment in hospitals
- To provide information and procedures for diagnosing or repairing a problem with an X-ray generator (correct)
What does Section 1 of the contents focus on?
What does Section 1 of the contents focus on?
- Preparing for radiographic exposure (correct)
- Repairing high-tension problems
- Testing X-ray tubes
- Diagnosing a problem with the X-ray generator
What does the control system do before permitting preparation to begin?
What does the control system do before permitting preparation to begin?
- It starts the exposure process immediately
- It checks the X-ray tube
- It performs high-tension tests
- It makes a number of safety tests (correct)
What happens if all tests are satisfied during the preparation mode?
What happens if all tests are satisfied during the preparation mode?
Which section focuses on diagnosing or repairing a problem with an X-ray generator?
Which section focuses on diagnosing or repairing a problem with an X-ray generator?
What are flow charts provided for in the content?
What are flow charts provided for in the content?
What could be the reason for no sound of X-ray tube anode rotation?
What could be the reason for no sound of X-ray tube anode rotation?
When would a warning light indicate a fault in the generator?
When would a warning light indicate a fault in the generator?
What would cause a warning light indicating wrong exposure factors?
What would cause a warning light indicating wrong exposure factors?
What happens if the combination of a high value of mA and a low value of kV is selected?
What happens if the combination of a high value of mA and a low value of kV is selected?
Why might selecting a very short exposure time combined with a low mA prevent operation?
Why might selecting a very short exposure time combined with a low mA prevent operation?
What should be done if the X-ray control microprocessor has calculated the amount of heat in the X-ray tube anode to be exceeded?
What should be done if the X-ray control microprocessor has calculated the amount of heat in the X-ray tube anode to be exceeded?
What do modern microprocessor-controlled generators have in special display modes?
What do modern microprocessor-controlled generators have in special display modes?
What would cause a warning light to indicate operator error?
What would cause a warning light to indicate operator error?
When might a small symbol indicate excessive anode heat on the control panel?
When might a small symbol indicate excessive anode heat on the control panel?
What type of message might be displayed with microprocessor-controlled generators?
What type of message might be displayed with microprocessor-controlled generators?
