Workshop Material Handling and Tool Calibration Quiz

Play an AI-generated podcast conversation about this lesson

Which type of diagram is a schematic diagram?

A diagram that shows the pictorial representation of components

A diagram that shows the block-level arrangement of components

A diagram that shows the physical arrangement of components

A diagram that shows the functional relationship between components (correct)

What is the color of a dry powder fire extinguisher and for which fire class is it suitable?

Red color, suitable for fire class B and C (correct)

Yellow color, suitable for all classes of fire

Green color, suitable for fire class A

Blue color, suitable for most classes of fire

After a heavy landing, which engine component should be checked?

Engine module alignment

Engine thrust alignment

Engine fuel system alignment

Engine compressor shaft alignment (correct)

Which type of fire extinguisher can be used in the aircraft cabin?

B.C.F. (Bromochlorodifluoromethane) or water extinguisher Signup and view all the answers

How should precision instruments be stored and handled?

With great care, both in storage and in use, and kept in special boxes Signup and view all the answers

When comparing the machining techniques for stainless steel sheet material to those for aluminum alloy sheet, it is normally considered good practice to drill the stainless steel at a:

Lower speed with less pressure applied to the drill Signup and view all the answers

Which of the following is the most correct reason to have firm control over the handling of materials used in workshops?

Safety, management, and economy Signup and view all the answers

The purpose of having a sticker attached to a tool that details the date of the next calibration is to:

Indicate that the tool should not be used if it is out of calibration Signup and view all the answers

When using a 'GO / NO-GO' gauge, which of the following is being checked?

Tolerance Signup and view all the answers

When disassembling or removing a component from an aircraft, which of the following is the most important action to take with small items like bolts, screws, nuts, washers, and shims?

Identify them by part number, location, and aircraft Signup and view all the answers

To ensure protection against HIRF (High-Intensity Radiated Fields) affecting audio and navigation aids, which of the following actions is most important?

All of the above Signup and view all the answers

What is the recommended action to take with a common circlip that has been removed from a component?

Carefully clean and inspect the circlip before reinstalling it Signup and view all the answers

What is the primary purpose of grounding an aircraft?

To prevent the development of radio frequency potentials Signup and view all the answers

If an insulation test on a group of cables yields a low reading, what should be done?

Break down the circuit and conduct further checks Signup and view all the answers

When should a Certificate of Release to Service be issued?

After a repair has been carried out according to an approved scheme Signup and view all the answers

Following a reported heavy or overweight landing, what must be inspected?

Both the primary and secondary structures Signup and view all the answers

Where should a chain be disconnected during maintenance?

At a spring clip joint Signup and view all the answers

If a control chain can be lifted clear of a tooth, what action should be taken?

Remove the chain and perform an elongation check Signup and view all the answers

Workshop Material Handling and Tool Calibration Quiz

Choose a study mode

Podcast

Questions and Answers