Podcast
Questions and Answers
What is the main reason for following lockout/tagout procedures when adjusting the Tensioner in preparation for removing the Cutter Assembly?
What is the main reason for following lockout/tagout procedures when adjusting the Tensioner in preparation for removing the Cutter Assembly?
- To avoid voiding the warranty of the equipment
- To make the adjustment process smoother
- To prevent serious injury or equipment damage in case of accidental restart (correct)
- To increase tension consistently
What should be done with the Film Drive Wheels during normal operation?
What should be done with the Film Drive Wheels during normal operation?
- Loosen them to remove the Mandrel
- Adjust them manually only
- Tighten them to stabilize the Mandrel (correct)
- Keep them away from the Film Drive Bearings
Why is it important to hold the Mandrel firmly while adjusting the Support Wheels?
Why is it important to hold the Mandrel firmly while adjusting the Support Wheels?
- To ensure that the film is advanced consistently
- To avoid damaging the LX-350
- To prevent the Mandrel from falling (correct)
- To prevent slippage of the Film Drive Wheels
When should the Support Wheels be loosened?
When should the Support Wheels be loosened?
What happens if the Upper Support Wheels are not adjusted properly?
What happens if the Upper Support Wheels are not adjusted properly?
What determines the orientation of the label design on the final product?
What determines the orientation of the label design on the final product?
What does 'Seam In vs Seam Out' refer to in relation to labels on bottles?
What does 'Seam In vs Seam Out' refer to in relation to labels on bottles?
Why might it be important for labels to come off the roll Bottom Out First?
Why might it be important for labels to come off the roll Bottom Out First?
What should be done to the Tensioner when removing or installing the Cutter Assembly?
What should be done to the Tensioner when removing or installing the Cutter Assembly?
Why is it crucial for labels to be oriented correctly on the UR-2 machine?
Why is it crucial for labels to be oriented correctly on the UR-2 machine?
