Podcast
Play an AI-generated podcast conversation about this lesson
Download our mobile app to listen on the go
Get App
Questions and Answers
During the startup process, what should you do if leaks occur from the fittings?
During the startup process, what should you do if leaks occur from the fittings?
- Increase the pressure control
- Tighten the leaking fittings
- Repeat the Setup/Startup process
- Perform the Pressure Relief Procedure (correct)
What should you do after allowing fluid to circulate for 15 seconds during the startup process?
What should you do after allowing fluid to circulate for 15 seconds during the startup process?
- Turn the pressure down and turn the prime valve horizontally (correct)
- Assemble tips and guards
- Increase the pressure control and turn the pump switch to OFF
- Disengage the trigger lock and hold all guns against a metal flushing pail
What should you do after flushing the system with a flushing fluid pail?
What should you do after flushing the system with a flushing fluid pail?
- Inspect fittings for leaks
- Place the siphon tube into paint pails
- Assemble tips and guards (correct)
- Trigger all guns again into a flushing fluid pail
What should you use to press OneSeal into the tip guard during assembly?
What should you use to press OneSeal into the tip guard during assembly?
Signup and view all the answers
What should you do after inserting SwitchTip into the tip bore during assembly?
What should you do after inserting SwitchTip into the tip bore during assembly?
Signup and view all the answers
What is the purpose of the trigger lock during assembly?
What is the purpose of the trigger lock during assembly?
Signup and view all the answers
Flashcards are hidden until you start studying
