Switch Verification Commands and SVI Configuration Quiz

Choose a study mode

Play Quiz

Study Flashcards

Spaced Repetition

Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

Which statement best describes the purpose of Alternate (Blocked) Ports in Spanning Tree Protocol (STP)?

They are used to provide redundant paths in case the Root Port fails.
They are placed in a discarding or blocking state to prevent switching loops. (correct)
They are used to connect multiple switches in a hierarchical network topology.
They are used to forward traffic when the Root Port is congested.

What is the purpose of the Root Port in Spanning Tree Protocol (STP)?

It is the port that is closest to the root bridge in terms of overall cost. (correct)
It is the port that is farthest from the root bridge in terms of overall cost.
It is the port that is used to connect the switch to other non-root bridges.
It is the port that is used to connect the switch to the root bridge directly.

What is the purpose of an EtherChannel in computer networking?

It is a virtual interface that combines multiple physical interfaces into a single logical interface. (correct)
It is a protocol used to automatically assign IP addresses to devices on a network.
It is a type of network cable used to connect switches and routers.
It is a protocol used to prevent switching loops in a network.

What is the purpose of the PAgP 'on' mode in EtherChannel configuration?

It forces the interface to form an EtherChannel without exchanging PAgP packets. (B) Signup and view all the answers

What is the purpose of the PAgP 'desirable' mode in EtherChannel configuration?

It places the interface in an active negotiating state, initiating negotiations with other interfaces by sending PAgP packets. (B) Signup and view all the answers

What is the purpose of the DHCP Request message in the DHCP process?

It is sent by the DHCP client to accept the offered IP address from the DHCP server. (B) Signup and view all the answers

What is the purpose of the PAgP 'auto' mode in EtherChannel configuration?

It places the interface in a passive negotiating state, responding to PAgP packets but not initiating negotiation. (D) Signup and view all the answers