Starting a Small Steam Turbine for Boiler Feedwater Pump
10 Questions
1 Views

Choose a study mode

Play Quiz
Study Flashcards
Spaced Repetition
Chat to lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

What is the first step in starting a small non-condensing steam turbine driving a feedwater pump?

  • Clear any lockouts or tagouts on the pump being started (correct)
  • Check the bearing lube oil levels and add oil if necessary
  • Start bearing cooling water, if applicable
  • Conduct a valve line-up
  • Why is it important to check the area surrounding the pump for rags, tools, or other materials before starting the pump?

  • To open the pump warm-up line
  • To ensure that the pump casing drains are closed
  • To start bearing cooling water, if applicable
  • To avoid hampering the operation of the pump (correct)
  • When starting a centrifugal pump, in what position should the discharge valve be?

  • Depends on the temperature of the pump
  • Open
  • Partially open
  • Closed (correct)
  • What is the purpose of opening the pump warm-up line when starting a small non-condensing steam turbine driving a feedwater pump?

    <p>To circulate hot boiler feed through the pump to warm it up</p> Signup and view all the answers

    Who should give the direction for starting or stopping pumps and turbines?

    <p>Shift engineer or control room operator</p> Signup and view all the answers

    What should be done first before starting the turbine?

    <p>Clear any lockouts or tagouts on the turbine being started.</p> Signup and view all the answers

    What is the correct step for warming up the turbine after ensuring the steam header is at operating pressure?

    <p>Slowly warm up the steam line to the turbine and then close the manual drain and trap bypasses.</p> Signup and view all the answers

    What should be checked while the turbine is on a slow roll?

    <p>The cooling system is at proper temperature ranges.</p> Signup and view all the answers

    What should be done after manually testing the overspeed trip during turbine startup?

    <p>Close the steam inlet to the turbine.</p> Signup and view all the answers

    What is a general instruction for stopping a small steam turbine driving a feedwater pump?

    <p>Gradually reduce feedwater pump load and then turn off cooling water to the pump and turbine lube oil systems.</p> Signup and view all the answers

    More Like This

    Use Quizgecko on...
    Browser
    Browser