Skycoaster Operations and Safety

Choose a study mode

Play Quiz
Study Flashcards
Spaced Repetition
Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

What is the maximum allowed wind speed for Skycoaster operations?

  • 25 MPH
  • 32 MPH but not including (correct)
  • 35 MPH
  • 30 MPH

What is the correct order of training for a new Site Controller candidate?

  • Flight Suiter, Expediter, Assistant Controller, Controller (correct)
  • Expediter, Assistant Controller, Flight Suiter, Controller
  • Flight Suiter, Expediter, Controller, Assistant Controller
  • Assistant Controller, Flight Suiter, Controller, Expediter

How often must all Hydraulic Fluid be drained and replaced?

  • annually (correct)
  • weekly
  • monthly
  • daily

What is the maximum capacity for a scissor lift?

<p>Ten People or 2000 pounds (C)</p> Signup and view all the answers

If footbar eyebolts on the flight suits are attached with a standard hex nut instead of the required zinc plated nylon insert locknut, can the flight suits still be used?

<p>No, the flight suits must be replaced immediately (C)</p> Signup and view all the answers

When a site is shorthanded on crew members, who can perform the duties of the Flight Crew?

<p>The Senior Site Controller (B)</p> Signup and view all the answers

What is the recommended pressure setting for the Hydraulic Landing Unit on a Skycoaster?

<p>350 psi (A)</p> Signup and view all the answers

Who appoints the Senior Site Controller to oversee Skycoaster operations and act as a liaison with Skycoaster?

<p>A Skycoaster representative (D)</p> Signup and view all the answers

What is the minimum wind speed at which Skycoaster operations should be limited?

<p>20 miles per hour (B)</p> Signup and view all the answers

What is the first thing the Assistant Controller says to new flyers at a site utilizing the rolling boarding platform?

<p>Stand on the yellow line and hold your footbars (B)</p> Signup and view all the answers

What is the responsibility of the Senior Site Controller when preparing candidates for Site Controller certification?

<p>Ensuring all candidates are ready and have a minimum of 8 hours training in each applicable position (D)</p> Signup and view all the answers

Is a completed Skycoaster Inspection Log required to be included with all 3rd Party Inspections?

<p>False (A)</p> Signup and view all the answers

What is the minimum height requirement for a traditional Flight Suit?

<p>42 inches (A)</p> Signup and view all the answers

Who is responsible for reviewing the Skycoaster Owner's Manual with new employees?

<p>Senior Site Controller (A)</p> Signup and view all the answers

What should you do if flyers are aloft and cannot or will not release, and the winch will not properly winch down?

<p>Lower by using the hydraulic bypass valve (A)</p> Signup and view all the answers

How should the anemometer be mounted on the flight or launch tower?

<p>No lower than 3/4 of the way up the tower (D)</p> Signup and view all the answers

What is the purpose of the thimble, swage, and flemish eye on a piece of equipment?

<p>To secure the flight car to the launch cable (A)</p> Signup and view all the answers

What must be securely tethered in place during each and every flight?

<p>The rolling boarding platform (B)</p> Signup and view all the answers

Flashcards are hidden until you start studying

Study Notes

Launch Cable Settings

  • The "UP" setting on the launch cable has a yellow tape color.

Equipment Identification

  • A thimble, swage, and flemish eye can be found on a Flight Cable.

Minimum Height Requirements

  • The minimum height requirement for a traditional Flight Suit is 42 inches.

Senior Site Controller Responsibilities

  • The Senior Site Controller is the only person authorized to review the Skycoaster Owner's Manual with new employees.

Attachment Area Procedures

  • In the Attachment Area, side clips are the "first things on, last things off".

Emergency Procedures

  • If flyers are aloft and cannot or will not release, and the winch will not properly winch down, the procedure is to lower by using the hydraulic bypass valve.

Anemometer Installation

  • The anemometer must be mounted no lower than 3/4 of the way up the flight or launch tower and must be secured with redundant connections.

Rolling Boarding Platform

  • The rolling boarding platform will be securely tethered in place during each and every flight.

Skycoaster Operations

  • Skycoaster operations are allowed in sustained winds up to, but not including, 30 MPH.

Certification Requirements

  • Flight line performance is not the sole determining factor in the certification of a new Site Controller candidate.

Training Order

  • The correct training order is: Expediter, Assistant Controller, Flight Suiter, Controller.

Hydraulic Fluid Maintenance

  • All Hydraulic Fluid must be drained and replaced annually.

Scissor Lift Capacity

  • The maximum capacity for a scissor lift is Ten People or 2000 pounds.

Flight Suit Inspection

  • If footbar eyebolts on the flight suits are found to be attached with a standard hex nut instead of the required zinc plated nylon insert locknut, the flight suits cannot be used.

Flight Bracket Components

  • The cotter pin on the Flight Bracket must be made of stainless steel.
  • The number of Crosby Wire Rope Clips used to secure the secondary loops on the flight bracket is 2.

Crew Member Responsibilities

  • When a site is shorthanded on crew members, only the Senior Site Controller may perform the duties of the Flight Crew.

Inspection Logs

  • A completed Skycoaster Inspection Log must be included with all 3rd Party Inspections.

Senior Site Controller Appointment

  • The Senior Site Controller is appointed by the individual site and oversees all Skycoaster operations and acts as a liaison with Skycoaster.

Hydraulic Landing Unit

  • The recommended pressure setting for MEDIUM on the Hydraulic Landing Unit is 350 psi.

Assistant Controller Responsibilities

  • At a site utilizing the rolling boarding platform, the first thing the Assistant Controller says to the new flyers is "Stand on the yellow line and hold your footbars."

Site Controller Certification

  • When preparing candidates for Site Controller certification, it is the responsibility of the Senior Site Controller to ensure that all candidates are ready and have a minimum of 8 hours training in each applicable position.

Studying That Suits You

Use AI to generate personalized quizzes and flashcards to suit your learning preferences.

Quiz Team
Use Quizgecko on...
Browser
Browser