Podcast
Play an AI-generated podcast conversation about this lesson
Questions and Answers
What should be done after lifting the cover weight in the upper position?
What should be done after lifting the cover weight in the upper position?
- Bolt the centering device
- Operate the lifting beam
- Disassemble the pneumatic connections
- Remove logs from the mould (correct)
When should the safety claws be closed during the process?
When should the safety claws be closed during the process?
- While removing the guide bearing
- When isolating as per LOTOV
- After removing logs from the mould
- Before lifting the cover weight (correct)
What is the purpose of placing a temporary platform during the process?
What is the purpose of placing a temporary platform during the process?
- To support the height measuring device
- To serve as a working surface (correct)
- To remove the guide bearing
- To lift the cover weight
Why should the fittings at pneumatic/greasing connections be loosened?
Why should the fittings at pneumatic/greasing connections be loosened?
Signup and view all the answers
What is the purpose of installing the assembly bush on the guide rod?
What is the purpose of installing the assembly bush on the guide rod?
Signup and view all the answers
What should be done to replace the double air bellow cylinder at the cover weight?
What should be done to replace the double air bellow cylinder at the cover weight?
Signup and view all the answers
When should the guide bearing be removed during the replacement process?
When should the guide bearing be removed during the replacement process?
Signup and view all the answers
Why is it necessary to isolate as per LOTOV during this process?
Why is it necessary to isolate as per LOTOV during this process?
Signup and view all the answers
What is the purpose of lowering the guide bearing into the vacuum hood?
What is the purpose of lowering the guide bearing into the vacuum hood?
Signup and view all the answers
Why should fittings at pneumatic/greasing connections be loosened during the replacement process?
Why should fittings at pneumatic/greasing connections be loosened during the replacement process?
Signup and view all the answers
