Proceso de Impulsión de Agua con Espuma

Procedure to deliver water-foam mixture using the machine.

Nozzle position to direct the water-foam mix; typically a fan-like shape.

Adjusting the foam concentration through a lever adjusting the foam's output by approximately a quarter turn.

Using the pump to draw water into the system using a specialized white hose with the pressure regulator set to "bypass" position and a specific valve in a perpendicular position..

Drawing water from a reservoir or other source using a hose reel, the yellow hose, to quickly aspirate water.

Drawing water into the system using gravity through the white hose, which requires the valve lever to be in a specific position.

Steps to turn off the water pump system, including valve changes and equipment disconnections in reverse order from start-up.

Initiating the pump's operation, independent of valve positions, but ideally with all valves(especially 15 and 16) closed. The pressure regulator (14) should be in Bypass (no pressure) position.

Adjusting the pump's pressure output. The pressure regulator (14) has two positions: Bar(with pressure) and Bypass. A third position, adjusting pressure directly, is available but only when needed. Target pressure is 40 bars.

Delivering water without foam. Follows a 5-step process involving valve positions and accelerator adjustments to achieve 40 bars of pressure.

Valve (19) position dictates the water source routing to the pump. Left-horizontal-position for water from storage tank.

Opens the clean water circuit.

Vertical position enables water discharge (clean water).

The pressure regulator should be in "Bypass" position when not projecting water to extend the pump's lifespan and avoid unwanted movements when not in use. It adjusts water pressure to the desired level of 40 bars.

During cold weather, or initial starts, adjust the air intake (13) to aid in starting the pump. The air lever has two positions.

Procedure to deliver a water-foam mixture using the machine.

Using the pump to draw water into the system. Regulator in 'Bypass', valve 19 perpendicular.

Water draw from a reservoir or other source using a hose reel and yellow hose. Pump must have sufficient water reserve.

Water drawn by gravity using the white hose. Valve 19 position for gravity flow

Steps to turn off the water pump, reversing the start-up process.

Valve position that determines the water source, affecting aspiration and discharge to tank.

Controls water pressure to the desired level. Two positions: Bar (pressure) and Bypass (no pressure).

Initiating pump operation, independent of valve positions, but ideally with all valves (especially 15 and 16) closed. Pressure regulator (14) should be in Bypass (no pressure).

Adjusting pump pressure output. Regulator (14) has Bar (with pressure) & Bypass positions. A third position adjusts pressure directly (if needed). Target: 40 bars.

Delivering water without foam. 5 steps: nozzle connection, valve 19 positioning, filter/valve 16 opening, valve 18 positioning, adjusting accelerator to 40 bars (initial setting).

Controls water source routing to the pump. Left-horizontal position for water from storage tank.

Opens the clean water circuit.

Vertical position enables water discharge.

Use air intake (13) to aid in starting during cold weather, or initial starts; it has 2 positions for this.

Use "Bypass" when not projecting to prevent unnecessary wear & tear. Adjust for 40 bars.