Podcast
Questions and Answers
What is the purpose of the strain measurement setup described in the manual?
What is the purpose of the strain measurement setup described in the manual?
- To examine the effect of temperature on strain gauges.
- To test the electric conductivity of brass strips.
- To study the utilization of a cantilever beam as a force measurement device. (correct)
- To investigate the properties of different metals used in cantilever beams.
In the system described, which configuration of strain gauges is used to constitute the four active arms of a measuring bridge?
In the system described, which configuration of strain gauges is used to constitute the four active arms of a measuring bridge?
- RG1 and RG3 in tension, RG2 and RG4 in compression. (correct)
- RG1 and RG2 in tension, RG3 and RG4 in compression.
- RG1 and RG4 in tension, RG2 and RG3 in compression.
- RG1 and RG2 in compression, RG3 and RG4 in tension.
Why is a full bridge configuration of strain gauges preferred over a single strain gauge system?
Why is a full bridge configuration of strain gauges preferred over a single strain gauge system?
- It requires less calibration.
- It is more resistant to temperature changes.
- It provides x4 higher sensitivity. (correct)
- It is cheaper to implement.
How is an offset voltage corrected in the described setup?
How is an offset voltage corrected in the described setup?
What type of potential is used to excite the measuring bridge in the setup?
What type of potential is used to excite the measuring bridge in the setup?
Why is automatic temperature compensation achieved in the measuring bridge setup?
Why is automatic temperature compensation achieved in the measuring bridge setup?
What is the purpose of adjusting the zero adjustment pot?
What is the purpose of adjusting the zero adjustment pot?
What should be the relationship between the applied force and the measured strain, according to the instructions?
What should be the relationship between the applied force and the measured strain, according to the instructions?
What is the purpose of measuring the reference voltage (Vr) across the ground and REF socket?
What is the purpose of measuring the reference voltage (Vr) across the ground and REF socket?
What is the recommended procedure for verifying the strain gauge calibration?
What is the recommended procedure for verifying the strain gauge calibration?
What is the purpose of measuring the analog voltage (Van) at the output?
What is the purpose of measuring the analog voltage (Van) at the output?
What is the expected shape of the curve when plotting strain against applied force?
What is the expected shape of the curve when plotting strain against applied force?
What is the primary application of a strain gauge cantilever arrangement?
What is the primary application of a strain gauge cantilever arrangement?
If a load is applied to a specimen in the direction 'f', what happens to the strain gauges?
If a load is applied to a specimen in the direction 'f', what happens to the strain gauges?
What is the relationship between the bridge output voltage (AV) and the strain (ε) in a strain gauge bridge?
What is the relationship between the bridge output voltage (AV) and the strain (ε) in a strain gauge bridge?
What does the term 'gauge factor' (GF) represent in the strain gauge bridge equation?
What does the term 'gauge factor' (GF) represent in the strain gauge bridge equation?
What is the purpose of the signal conditioning circuit mentioned in the text?
What is the purpose of the signal conditioning circuit mentioned in the text?
What is the relationship between the applied force and the bridge output voltage (AV)?
What is the relationship between the applied force and the bridge output voltage (AV)?
Flashcards are hidden until you start studying
