Recent Lessons

Show all results for ""

Mastering Video Inspection Procedures in Law Enforcement

Choose a study mode

Play Quiz

Study Flashcards

Spaced Repetition

Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson

Questions and Answers

Which section of the Department Manual provides information on the objectives of Body Worn Video?

Section 3/579.13
Section 4/289
Section 3/579.15 (correct)
Section 4/217.50

When should BWV and/or DICVS be activated during investigative or enforcement activity?

Only when specifically excluded by policy
Always
Only when required by policy (correct)
Never

What is the requirement for the pre-activation buffer video for BWV?

One minute
Two minutes (correct)
No requirement
Three minutes

What should be done if a BWY is not properly tagged with the correct incident number on Evidence.com?

Send it to the appropriate Area/division for correction (A) Signup and view all the answers

According to the text, which objective is considered an administrative deviation?

Objective No. 1: Start of Watch Checks (A) Signup and view all the answers

According to the text, what is the purpose of generating multiple SAI's?

To generate a review period for administrative deviations (C) Signup and view all the answers

According to the text, what is the condition for using progressive discipline?

Any intentional act to circumvent Department policy or procedure (A) Signup and view all the answers

According to the notice, what parameters are used with the One-Tailed Test to determine the relevant sample size for each Area/division?

A 95 percent confidence level, a Standardized Normal Distribution coefficient of 1.96, a Proportion of Success Rate of 95 percent, and an acceptable error rate not to exceed five percent (B) Signup and view all the answers

What is the purpose of the inspection procedures mentioned in the notice?

To establish standardized inspection procedures for Body Worn Video (BWV) and Digital In-Car Video System (DICVS) video recordings (C) Signup and view all the answers

What is the acceptable error rate for the One-Tailed Test used in the inspection procedures?

Not to exceed five percent (D) Signup and view all the answers

Flashcards are hidden until you start studying