Podcast
Questions and Answers
Which components must be installed before the cage is re-installed into the shaft?
Which components must be installed before the cage is re-installed into the shaft?
- Clamps, powerpack, and all pipes
- Clamps, powerpack, and most pipes (correct)
- Clamps, powerpack, and certain pipes
- Clamps, powerpack, and some pipes
Which statement is true about the weight of the equipment?
Which statement is true about the weight of the equipment?
- The mass of the equipment ranges from 50 to 1000 kg
- The mass of the equipment ranges from 75 to 450 kg
- The mass of the equipment ranges from 85 to 500 kg (correct)
- The mass of the equipment ranges from 100 to 600 kg
What should be ensured before installing spare clamps?
What should be ensured before installing spare clamps?
- Required holes and brackets are on the new cage (correct)
- Required holes and brackets are on the pipes
- Required holes and brackets are on the old cage
- Required holes and brackets are on the powerpack
How should the clamps be installed?
How should the clamps be installed?
What should be ensured about the male quick release coupler?
What should be ensured about the male quick release coupler?
Which of the following is a possible cause for the intensifier not starting when the airline is connected to the cage?
Which of the following is a possible cause for the intensifier not starting when the airline is connected to the cage?
What should be done if there is insufficient oil in the tank and the pump runs continuously or stalls but gives an occasional pump stroke?
What should be done if there is insufficient oil in the tank and the pump runs continuously or stalls but gives an occasional pump stroke?
What could be the cause if the pump takes too long to start after connecting the air supply to the cage?
What could be the cause if the pump takes too long to start after connecting the air supply to the cage?
What should be checked if the cage oscillates after the release of the clamps or if the cage release takes too long?
What should be checked if the cage oscillates after the release of the clamps or if the cage release takes too long?
What should be done if the clamps are already applied and it is indicated on the panel, but the pump stalls and gives an occasional pump stroke?
What should be done if the clamps are already applied and it is indicated on the panel, but the pump stalls and gives an occasional pump stroke?
Flashcards are hidden until you start studying
