LX-150 Power Connection Quiz

Play an AI-generated podcast conversation about this lesson

Which type of power supply does the LX-150 require?

1-phase, 240V 50/60 Hz grounded

1-phase, 120V 60 Hz grounded

3-phase, 220V 50/60 Hz grounded (correct)

3-phase, 208-240V 50/60 Hz grounded

What needs to be installed immediately downstream from the LX-150?

UR-1

Heat Shrink Tunnel

Brushdown Assemblies (correct)

Timing Screw

What is the purpose of the Brushdown Assemblies?

To shrink labels onto bottles

To push labels down into the correct location on the bottle (correct)

To attach the Power Plug

To shoot labels onto bottles

What type of power source does the LX-150 need to be connected to?

3-phase, 208-240V 50/60 Hz AC power source Signup and view all the answers

What is needed to attach the Power Plug to the LX-150?

All of the above Signup and view all the answers

Where is the Power Cable located on the LX-150?

Front downstream side of the Electronics Cabinet Signup and view all the answers

What should the bristles of the Brushdown Assemblies be exposed to?

The centerline of the Conveyor Signup and view all the answers

What is the voltage requirement for the Power Cable connection?

240V Signup and view all the answers

What is the frequency requirement for the Power Cable connection?

50/60 Hz Signup and view all the answers

What is the purpose of heat shrinking the labels onto the bottle?

To ensure labels do not slide back up the length of the bottle Signup and view all the answers

Which button on the Main Screen Tabs accesses the Parameter Setting Screens?

Setting Signup and view all the answers

What does the 'Fault Reset' button do?

Resets the alarm to be able to be triggered again Signup and view all the answers

Which screen can be accessed from the Other Screen and displays a log of the alarms triggered on the machine?

Alarm & Message Screen Signup and view all the answers

What does the 'Clear' button do on the Alarm & Message Screen?

Permanently deletes the selected fault from the log Signup and view all the answers

What is the purpose of the Knife Offset Screen?

To recalibrate the home position for the blades Signup and view all the answers

What is the function of the 'Set' button on the Knife Offset Screen?

Accepts the value entered into the 'Knife Offset' Field Signup and view all the answers

Which component of the LX-150 can be diagnosed using the PLC I/O Monitor Screens?

Cutter Blades Signup and view all the answers

What does a checked box indicate on the PLC I/O Monitor Screens?

The input or output for that component has been triggered Signup and view all the answers

Which button on the Other Screen accesses the History Message Screen?

History Signup and view all the answers

What are the four main screens in the software used to control the LX-150?

Other, Manual, Setting, Work Signup and view all the answers