Podcast
Questions and Answers
Which part should be checked every three weeks for signs of wear?
Which part should be checked every three weeks for signs of wear?
- Cutter Assembly
- Applicator Wheels
- Film Drive Wheels (correct)
- Mandrel
What should be used to clean the Applicator Wheels and Film Drive Wheels?
What should be used to clean the Applicator Wheels and Film Drive Wheels?
- Alcohol
- De-ionized water
- Soap and water
- Distilled water (correct)
How often should the Bearings in the Mandrel be replaced?
How often should the Bearings in the Mandrel be replaced?
- Every two years
- Every month
- Every year (correct)
- Every six months
Which tool is needed to replace the Cutter Blades?
Which tool is needed to replace the Cutter Blades?
What should be done if wear is observed on the Film Feed Drive Belt?
What should be done if wear is observed on the Film Feed Drive Belt?
During the process of removing the Cutter Guard, what should be done with the Screws?
During the process of removing the Cutter Guard, what should be done with the Screws?
What should be done with the old Cutter Blades?
What should be done with the old Cutter Blades?
What should be done if there is wear on the Timing Belt or the Cutter Drive Belt?
What should be done if there is wear on the Timing Belt or the Cutter Drive Belt?
Which tool should be used to clean the Eye of the Work Detective Sensor and Reflector?
Which tool should be used to clean the Eye of the Work Detective Sensor and Reflector?
Which item is needed to remove the Mandrel?
Which item is needed to remove the Mandrel?
Which Wheels should be loosened to remove the Mandrel?
Which Wheels should be loosened to remove the Mandrel?
What should be done to clean the Cutter Notch of the Mandrel?
What should be done to clean the Cutter Notch of the Mandrel?
Which component should be checked for wear and replaced at least once every 3 weeks?
Which component should be checked for wear and replaced at least once every 3 weeks?
What should be done if the Cutter Drive Belt shows signs of wear?
What should be done if the Cutter Drive Belt shows signs of wear?
How often should the Timing Belt be checked?
How often should the Timing Belt be checked?
What should be done if the Timing Belt needs adjustment?
What should be done if the Timing Belt needs adjustment?
Which of the following is NOT recommended for cleaning the LX-150 and UR-1?
Which of the following is NOT recommended for cleaning the LX-150 and UR-1?
Before cleaning the LX-150, what should you do?
Before cleaning the LX-150, what should you do?
What should you use to clean the surfaces inside the LX-150?
What should you use to clean the surfaces inside the LX-150?
How often should you clean the lens of the Print Reading Sensor?
How often should you clean the lens of the Print Reading Sensor?
Flashcards are hidden until you start studying
