Driver Op Policies

Play an AI-generated podcast conversation about this lesson

What is required when upgrading a Non-commercial firefighter Class C driver license to a Commercial Class A driver license?

Commercial Class A drive test (correct)

Commercial written testing only

Commercial Class B drive test

Commercial Class B drive test and written testing

When upgrading a Non-commercial firefighter B driver license to a Commercial Class B driver license, what happens to the drive test?

It is required

It becomes harder

It is waived (correct)

It is replaced with written testing

What is needed to upgrade a basic firefighter Class C to an Unrestricted Commercial B license?

Commercial Class B drive test only

Both Commercial Class B drive test and written testing (correct)

Commercial written testing only

Commercial Class A drive test

Who should be contacted for authorization to use department staff vehicles on weekends?

Battalion Chief Signup and view all the answers

What should be done before removing equipment or material from the Repair and Maintenance Section?

Get approval from the Fire Equipment Supervisor Signup and view all the answers

If a member is assigned a staff vehicle, what is their responsibility regarding regular maintenance?

Notify the Repair and Maintenance Section Signup and view all the answers

What should be done by persons desiring to purchase obsolete Department equipment?

Refer to the City of Fresno Purchasing Division Signup and view all the answers

What is the consequence of not following the protocol for sending equipment in need of repair to the Repair and Maintenance Section?

Loss of warranty on equipment Signup and view all the answers

What should the assisting firefighter wear for improved visibility during backing up?

Wildland jacket Signup and view all the answers

When should the driver stop immediately while backing up?

When the firefighter is out of view Signup and view all the answers

What type of lights should be used in traffic while backing up?

Red lights Signup and view all the answers

Which command is given using standardized hand signals to indicate 'Stop'?

'Hand up and palm facing forward' Signup and view all the answers

How much water is required to place an engine in service?

250 gallons Signup and view all the answers

What size hoses can be used to place an engine in service?

200 feet of 1-1/2-inch hose Signup and view all the answers

When can a chief officer place an apparatus in service?

When it is in the best interest of the city Signup and view all the answers

What should the company officer do if an apparatus needs to be placed on a delayed response for hose change?

Notify the Communications Center Signup and view all the answers

How much 2-1/2-inch hose is required to place an engine in service?

One full compartment Signup and view all the answers

Engines may be placed in service with a minimum of: • 250 gallons of water. • 200 feet of 1-1/2-inch hose or 1-3/4-inch hose. • Two (2) full compartments of 2-1/2-inch hose or one (1) full compartment of 2-1/2-inch hose and one (1) full compartment of large-diameter hose (LDH).

True Signup and view all the answers

What should be done after plugging in and securing the headlight during maintenance?

Recheck if the lights are operating properly Signup and view all the answers

Why is it important to ensure the lettering on the front of the bulb is upright?

To prevent the light beam from being out of alignment Signup and view all the answers

What action should always follow grasping the headlight and plastic wiring harness plug during maintenance?

Pulling the plug from the bulb until they separate Signup and view all the answers

Where should the engineer note the condition of an inspected apparatus?

At the bottom of the row representing the current date Signup and view all the answers

If a defect does not require immediate correction for safe operation, what should the mechanic do?

State such information on the back of the Pre-Trip Inspection Report Signup and view all the answers

If in doubt about the safety of a vehicle, who should be contacted according to the text?

Shop mechanic Signup and view all the answers

What should a driver do when the green light indicates the ignition switch is in the 'on' position?

Depress the starter button Signup and view all the answers

Why is it important to follow a proper cool down period after low-speed city driving?

To allow the turbo charger to adequately cool down Signup and view all the answers

What does a message stating 'No Data' and flashing icons indicate regarding the apparatus?

Loss of communication between chassis and gauges Signup and view all the answers

When should the electrical shoreline be attached to a parked apparatus?

After waiting for the engine to completely stop running Signup and view all the answers

In what order should a driver shut down an apparatus after parking it?

Turn the ignition switch off, turn battery master switch off, attach electrical shoreline Signup and view all the answers

What should be used to show the path of a vehicle before an accident according to the text?

Solid line Signup and view all the answers

How should a motorcycle be represented in the accident diagram as per the provided information?

o-o Signup and view all the answers

What does a railroad symbol look like in the accident diagram based on the text?

<ul> <li></li> </ul> Signup and view all the answers

How are pedestrians represented in the provided accident diagram instructions?

o Signup and view all the answers

What consequences does CVC 21055 warn drivers about?

Consequences of arbitrary exercise of privileges Signup and view all the answers

How often should air-brake systems on front-line emergency response apparatus be inspected according to the policy?

Daily and weekly basis. Signup and view all the answers

Where should the results of the air-brake system inspection be recorded?

Administrative Manual Section 106.023. Signup and view all the answers

What should the driver do after entering the event area at a speed necessitating quick judgment?

Wait until a proctor signals they are ready Signup and view all the answers

In the Three-Point Turnaround procedure, where should the driver set the parking brake?

After exiting the area through the delineators Signup and view all the answers

How should a driver determine when to stop while backing up an apparatus?

By watching for signs from an outside proctor Signup and view all the answers

What is the purpose of the Short Cones in the Diminishing Clearance setup?

To mark a safe stopping distance Signup and view all the answers

Why does the text mention entering the event area at a minimum speed of 15 MPH?

To make it easier to stop within 18 inches Signup and view all the answers