Dental Cast Mounting Procedure

The cut should be approximately 1/4 inch ______ and 1/2 inch width.

The mandibular cast is articulated after recording the vertical and centric jaw ______.

The base plate with occlusion rim should be sealed to the cast by ______.

The midline of maxillary cast should be coincided with the midline of mandibular cast and midline of ______.

Record base is not properly secured to the ______.

Preparation of the casts and mounting the upper cast on CL II articulator involves the procedure of attaching the maxillary and mandibular casts to the articulator in their recorded ______ relation

Centralization of maxillary cast with upper member of articulator then the centralization of lower cast which depend on accuracy of the maxillary ______.

The maxillary cast is first articulated, and then the mandibular cast is articulated after recording the vertical and centric ______ relations

We have 2 types of mounting: 1-Arbitrary mounting 2-Mounting using ______ bow

In mean value articulator (Class II articulator), the incisal pin should be flushed with the top of upper member of articulator to give zero ______

The ______ should be well secured to the mandibular cast with its record base by using wax

The articulator with the mounted maxillary cast is inverted to aid in the mounting the ______ cast

Care should be taken that there is no posterior interference between the maxillary and ______ casts (Heel area)

The maxillary occlusal rim with mandibular occlusal rim (centric record) placed on the maxillary ______

The mandibular cast is placed on the mandibular occlusal rim (It should be soaked in slurry water before ______)

The plaster is mixed and poured over the base of the mandibular cast and the articulator is closed until the incisal table touch the incisal pin, then the plaster should be smoothed and ______