Compressor Output Control Methods

Choose a study mode

Play Quiz
Study Flashcards
Spaced Repetition
Chat to Lesson

Podcast

Play an AI-generated podcast conversation about this lesson
Download our mobile app to listen on the go
Get App

Questions and Answers

What is the purpose of the start and stop control method in a compressor system?

  • To protect the motor from overloading
  • To maintain a constant pressure in the system
  • To shut down the compressor when little or no air is required (correct)
  • To control the compressor speed

Why is it important to have a sufficiently large receiver in the start and stop control method?

  • To reduce compressor wear and tear
  • To avoid continuous starting and stopping of the compressor (correct)
  • To increase the efficiency of the motor
  • To ensure the compressor operates less than 50 percent of the time

What is the role of the unloader in a compressor system?

  • To switch on and off the compressor
  • To sense the pressure in the receiver
  • To load and unload the compressor based on speed (correct)
  • To vary the flow of air from the compressor

Which type of control method is specifically mentioned as being used only for electric motor driven units?

<p>Start and stop control (B)</p> Signup and view all the answers

How does the unloader valve operate in a compressor system?

<p>It opens when the compressor stops and closes when it starts operating (D)</p> Signup and view all the answers

Why should the compressor be automatically unloaded during startup?

<p>To avoid overloading the motor (A)</p> Signup and view all the answers

What is the purpose of the unloader valve in a reciprocating compressor system?

<p>To reduce pressure in the discharge pipe when the compressor stops (A)</p> Signup and view all the answers

In which situation would a pilot type unloader vary the output from the compressor according to air demand?

<p>When the compressor is very large (D)</p> Signup and view all the answers

What is the purpose of holding the inlet valves open in a compressor with load/unload control?

<p>To allow air to pass freely without gaining compression (D)</p> Signup and view all the answers

Which type of control method allows for adjusting compressor speed by varying the motor speed, regulating steam supply, or regulating fuel supply?

<p>Variable Speed Control (B)</p> Signup and view all the answers

When does a compressor with dual capacity control shut down?

<p>After running at full load for a specific time (A)</p> Signup and view all the answers

What is the function of protective controls in a compressor system?

<p>To prevent damage or catastrophic failure (A)</p> Signup and view all the answers

In load/unload control, what happens to the inlet valve when the compressor is unloaded?

<p>It opens fully allowing free flow of air (C)</p> Signup and view all the answers

How does a variable speed control method respond to an increased demand for air?

<p>By increasing compressor speed (C)</p> Signup and view all the answers

What does an inlet valve unloader do when a compressor is loaded?

<p>It remains closed. (B)</p> Signup and view all the answers

Why is a pilot type unloader used in compressors that are very large?

<p>To vary output based on air demand. (B)</p> Signup and view all the answers

Flashcards are hidden until you start studying

More Like This

Use Quizgecko on...
Browser
Browser