Podcast
Questions and Answers
What is the consequence of the CM2 control column being jammed?
What is the consequence of the CM2 control column being jammed?
- Options B and C are correct. (correct)
- Both elevators can be moved with the left control column above 195 kts IAS.
- Only the left elevator can be moved below 195 kts IAS.
- It is not possible to move any elevator above 195 kts IAS.
What systems can you switch off the hydraulic supply to by means of the SERVO CTL PB switches?
What systems can you switch off the hydraulic supply to by means of the SERVO CTL PB switches?
- All three systems.
- Maximum one system.
- Maximum two systems, the third PB is locked in this case. (correct)
- Maximum two systems; pushing the third system PB reactivates all three systems.
What does the SERVO CTL JAM light indicate a jam of?
What does the SERVO CTL JAM light indicate a jam of?
- A control valve of the primary flight control units. (correct)
- The horizontal stabilizer.
- The roll spoilers.
- A flap or slat motor.
What happens if a wing tip brake of the flaps system has engaged?
What happens if a wing tip brake of the flaps system has engaged?
What action is required to regain compass information after pushing the ATT/HDG PB switch?
What action is required to regain compass information after pushing the ATT/HDG PB switch?
What is the minimum pavement width needed to make a 180° turn?
What is the minimum pavement width needed to make a 180° turn?
How is the Main Deck Cargo Door operated?
How is the Main Deck Cargo Door operated?
Which statement about the Main Deck Cargo Compartment is true?
Which statement about the Main Deck Cargo Compartment is true?
What does a UNLK red light for the RH main landing gear indicate?
What does a UNLK red light for the RH main landing gear indicate?
What happens when the stickshaker is activated?
What happens when the stickshaker is activated?
What must be met to engage an AP?
What must be met to engage an AP?
When the ALT HLD mode PB is pushed during climb with V/S mode active and the altitude selected is not reached, what happens?
When the ALT HLD mode PB is pushed during climb with V/S mode active and the altitude selected is not reached, what happens?
When performing a landing in LAND mode, until what altitude must the LAND PB be pushed?
When performing a landing in LAND mode, until what altitude must the LAND PB be pushed?
What happens when the ALT SEL knob is turned during a climb to a new flight level with ALT HLD / SPD active?
What happens when the ALT SEL knob is turned during a climb to a new flight level with ALT HLD / SPD active?
What occurs when actuating the rocking lever in AP 1 in CMD?
What occurs when actuating the rocking lever in AP 1 in CMD?
